[gvrp{on|off} ] [mvrp{on|off} ] [loose_binding{on|off} ] [ingress-qos-mapQOS-MAP] [egress-qos-mapQOS-MAP]protocolVLAN_PROTO- either 802.1Q or 802.1ad.idVLANID- specifies the VLAN Identifer to use. Note that numbers with a leading " 0 " or " 0x " are interpreted as octal or...
[ link-netnsid ID ][ alias NAME ][ vf NUM [ mac LLADDR ][ vlan VLANID [ qos VLAN-QOS ] ][ rate TXRATE ][ max_tx_rate TXRATE ][ min_tx_rate TXRATE ][ spoofchk { on | off} ][ query_rss { on | off} ][ state { auto | enable | disable} ] ][ trust { on | off}...
ip link add link DEVICE name NAME type vlan [ protocol VLAN_PROTO ] id VLANID [ reorder_hdr { on | off } ] [ gvrp { on | off } ] [ mvrp { on | off } ] [ loose_binding { on | off } ] [ bridge_binding { on | off } ] [ ingress-qos-map QOS-MAP ] [ egress-qos-...
vconfig set_egress_map [VLAN DEVICE NAME] [SKB_PRIORITY] [VLAN_QOS] vconfig set_ingress_map [VLAN DEVICE NAME] [SKB_PRIORITY] [VLAN_QOS] 查询VLAN 设备情况:cat /proc/net/vlan/[VLAN DEVICE NAME] 创建VETH 设备:ip link add link [DEVICE NAME] type veth ...
link DEVICE name NAME type vlan [ protocol VLAN_PROTO ] id VLANID [ reorder_hdr { on | off } ] [ gvrp { on | off } ] [ mvrp { on | off } ] [ loose_binding { on | off } ] [ bridge_binding { on | off } ] [ ingress-qos-map QOS-MAP ] [ egress-qos-map QOS-MAP ...
For connections to be re-established between sites through the MPLS VPN backbone area, a logical intra-area link must be established between the ingress and egress Virtual Routing and Forwarding (VRF) interfaces of the related PEs. This feature provides a solution to establish an OSPF sham link...
(可选)执行命令apply-label per-route pop-go,配置当前VPN实例IPv6地址族下所有发往对端PE的每条路由使用单独的标签值,并且当收到封装这个标签的数据报文后,系统将弹出标签并从ILM(Incoming Label Map,入标签映射表)中查找对应的出接口将数据报文转发出去。 通过配置apply-label per-route pop-go命令,本端设备在...
QosPortRange QueryInboundNatRulePortMappingRequest QueryRequestOptions QueryResults QueryTroubleshootingParameters RadiusServer 记录 ReferencedPublicIpAddress 资源 ResourceIdentityType ResourceNavigationLink ResourceNavigationLinksListResult ResourceSet RetentionPolicyParameters 路由 RouteFilter RouteFilterRule...
This use case provides the ability to assign a specific SRv6 locator for a given prefix or a set of prefixes. The egress PE advertises the prefix with the specified locator. This allows for per-prefix steering into desired transpor...
Internally, there is an accounting table associated with the traffic indexes to be created for each input (ingress) and output (egress) interface. The traffic indexes allow you to account for the IP traffic, where the source IP address, th...