drdo centre of excellence
In this tutorial, you will learn how to interface LCD with Arduino. We will be using Arduino Uno, but the same code and concepts work for other Arduino development boards also. Firstly,16×2 LCDinterfacing with Arduino will be discussed. After that, we will also provide examples of 16×4 ...
RFID interfacing with microcontroller 8051microcontroller ppt
#include<reg51.h> void lcd_init(void); void writecmd(int); void writedata(char); void delay(int); void check_col1(); void check_col2(); void check_col3(); In the first line, we add a header tag,reg51.h. This header file helps us deal with the 8051 microcontroller’s regist...
INTERFACING BLUETOOTH MODULE WITH 8051 (HC05): A Bluetooth module widely used with Microcontroller to enable Bluetooth communication. This module cam be interfaced using the UART in 8051 microcontroller where the data are transmitted in the form of packets. The pins TX and RX pin of the HC 05...
Interfacing LCD to 8051 Amol Shah 122889 Wiegand Interface Amol Shah 25349 Interfacing 7-Seg Display to Microcontroller Amol Shah 85939 Introduction to RC5 Protocol Amol Shah 34954 Methods for generating delay Amol Shah 44948 Serial Communication Basic Amol Shah 16713 Interfacing ADC0808 To 8051 Amol ...
Interfacing MINI-MAX Microcontroller Boards with Date: October 9, 2011 Document Revision: 1.02 BiPOM Electronics 16301 Blue Ridge Road, Missouri City, Texas 77489 Telephone: (713) 283-9970 Fax: (281) 416-2806 E-mail: info@bipom.com Web: www.bipom.com © 2011 by BiPOM Electronics, Inc...
Interface an LCD with 8051 in 4 bit mode Use a single port of the microcontroller for both data and control lines of the LCD. LCD Module to 8051 – 4 Bit Mode As shown in the circuit diagram, port 0 of the controller is used for interfacing it with LCD module. In 4 bit mode only...
devices. For example,7 segment display interfacing with 8051, LCD display interfacing with 8051, Matrix keypad interfacing with 8051,interfacing DS1307 RTC with 8051 microcontroller, interfacing 8051 with servo motor, interfacing DC motor with 8051, 8051 microcontroller interfacing with ADC, and so on...
RTC Interfacing with 8051 Microcontroller I2C devices have open drain outputs therefore, a pull-up resistors must be connected to the I2C bus line with a voltage source. If the resistors are not connected to the SCL and SDL lines, the bus will not work. ...