An apparatus for building a faux wood ceiling includes wooden beams and interlocking planks or panels. Each of the beams are attachable to a wall or ceiling. Each of the interlocking planks has a lip on one side and another lip on an opposite side. One lip engages with another lip of an...
In these scenarios, APs can be mounted on the steel beams beneath a building's roof. In this mounting mode, a beam for installing the device must be able to bear the weight four times the total weight of the device and mounting bracket without damage. When the total weight of the ...
When installing an AP on a spring tee ceiling, it is recommended that self-locking steel ropes be used to mount the AP on spring tees. The steel ropes should pass through the aluminum panel and bind the AP. Before installing the AP, determine the position of the spring...
While columns can be split on site, most manufacturers will do it for you. Split columns can't be used in load-bearing applications, and some manufacturers caution that they need to be installed as soon as possible after being cut to reduce the chance that stresses released during the splitt...
41 Attachment: Rigid Floor-mounted/Pad-mounted Step 1: Determine where to bolt the equipment Accurately draw the bolt pattern on the floor, concrete pad, or steel beams using one of the following methods: • Set the bumpers in place and mark the holes. • Use measurements and ...
An apparatus for building a faux wood ceiling includes wooden beams and interlocking planks or panels. Each of the beams are attachable to a wall or ceiling. Each of the interlocking planks has a lip on one side and another lip on an opposite side. One lip engages with another lip of an...
The ceiling is made up of blocks incorporating two downwardly directed slots which are positioned between pairs of conventional beams. The slots receive laths which are held in place by plaster. Insulation material is installed between the laths and is held in place by finishing panels which ...
The ceiling is made up of blocks incorporating two downwardly directed slots which are positioned between pairs of conventional beams. The slots receive laths which are held in place by plaster. Insulation material is installed between the laths and is held in place by finishing panels which ...