1. Unscrew the lock nut of the ground screw on the rear of the chassis adjacent to the ground symbol. 2. Place the ring terminal of the 10 AWG (4.0 mm2) Supplementary Ground Conductor on the ground screw. 3. Ti
b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. c) Install the second inner rail to the opposite side of the node. Figure 1: Attaching the Inner Rail to the Side of the Server Step 2 1 Keyed slots in rail 2 ...
In the Linux platform copy the file to the/var/opt/sun/portal/tmp/password.propertiesdirectory. Edit the/var/opt/SUNWportal/tmp/password.propertiesfile and replace the following values that begin and end with “%” with proper passwords. amadminPassword=%AMADMIN_PASSWORD% amldapuserPassword=%AM...
b.Close the left side of the cover, and press firmly along the edge to lock in place. c.Replace the screw at the front of the chassis. Step 12Connect the new system power cable to the power-supply 2 cable connector (PS2) on the back panel of the appliance. ...
Slide the secondary fan tray until the snap lock clicks in to place and the fan tray is seated completely. Step 7 Repeat steps 4 and 5 for the second secondary fan tray. This completes the procedure for installing the fan trays in a Cisco NCS 560-4 Router. ...
A restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security. Statement 1017 Warning Only trained and qualified personnel must be allowed to install, replace, or service this equipment. Statement 1030 Note Each new fabric...
Failed to lock config, aborting migration... Solution Use the migration command again. Problem In case a auto-boot is not disabled before the insertion of the Supervisor-4 Module, the following syslog message is displayed: <Tue Apr 30 10...
Failed to lock config, aborting migration ... Action to be performed Use the migrate sup kickstart system command again. Problem In case auto-boot is not disabled before the insertion of the supervisor-3E module, the following syslog m...
b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot has a metal clip that locks over the front peg. Step 2 1 Keyed installation slots 2 Front of node c) Install the second inner rail to the opposite ...
b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot has a metal clip that locks over the front peg. Step 2 1 Keyed installation slots 2 Front of node c) Install the second inner rail to the opposite ...