Pull the terminal block plug connector out of the terminal block head in the power supply. Step 5 Loosen the captive screws on the DC power supply. Step 6 Grasping the power supply handle with one hand, pull the power supply out from the chassis while ...
Connect the end of the console cable with the RJ45 connector to the light blue console port on the router. or Connect a USB Type A-to-Type A cable to the USB console port. If you are using the USB serial port for the first time on a Windows-based PC, instal...
The single coax N-connector is offset to the side of the mounting base, but can be custom modified to enter from the center of the mounting base post. ( 单个同轴N形连接器偏移到安装基座的侧面,但是可以自定义修改以从安装基座柱的中心进入。 ) Opening the hatch Torx 20( 打开舱口Torx 20 ) ...
10base2 or thinnet looks just like the coax cable that your cable TV probably uses. The connectors are a little different; they don't screw on like TV and Audio cable connectors do. Network cards designed for thinnet have a post sticking out of them; the "T" connector on the wire slip...
Procedure Step 1 Connect the end of the console cable with the RJ45 connector to the light blue console port on the router. or Connect a USB Type A-to-Type A cable to the USB console port. If you are using the USB serial port for the first time on a Windows-based PC, install the...
The terminal block connector is of suitable size to carry the appropriate AWG wire size (6AWG to 14 AWG) to handle the input current of the power supply. No ON/OFF switch is provided. AC power (A900-PWR1200-A): 85VAC to 264VAC The AC power supply has an I...
Step 2 Briefly touch the center of each cable connector with the jumper cable to remove any built-up ESD potential. Step 3 Position the UCH2 so the red line is on the same side as the red triangle on the faceplate. Figure 10 Installing the UCH2 ...
The Cisco Wireless Gateway for LoRaWAN is equipped with two N-type radio frequency (RF) connectors (antenna ports 1 and 2) on the top of the unit for LoRa antennas, and one TNC connector on the left of the unit for the GPS antenna, as shown in Antenna Connector Locati...
1 M8 x16 bolt (supplied with pole mount kit) 3 F-connector 2 M8 x16 bolt (supplied with pole mount kit) Step 5 Position the two bolts on the access point into the quick mount notches on each side of the mounting bracket (see Figure 2-23). Ensure that the hinged door is facing...
The wire wrap adapter is used to support the wire wrap interface for the BITS port on the RSP3 module. This adapter is plugged into the existing RJ-45 connector on the RSP3 module. Figure 19.Wire Wrap Adapter For information on pinouts, seeWire Wrap Adapter...