For the other door, well, it's made of metal. And I didn't really want to figure out what it'd take to put a deadbolt in a metal door. So, I searched for a smart lock that could replace a standard door knob. It turns out Yale has smart locks for that exact si...
Locks on the front and rear doors and the side panels use the same key. Pull the handle below the keyhole to detach the side panel's upper part from the bay. See step (2) in Figure 3-62. Remove the side panel from the bay. See step (3) in Figure 3-62. Routing cables on the...
Instructions for moving devices Do not lay a chassis on its front or back panel. Never drag a chassis. Stand a chassis upright and hold the load-bearing handles to lift and move it. When you move a chassis or device on a dolly, keep the chassis upright and stable. 4. Placing Boards ...
Bedroom Door Locks The lock on a bedroom door is designed to provide privacy, not to offer security or keep any intruders out. This is fortunate in the event that you need to open a locked bedroom door, because in an emergency, a high-security lock would be hard to hack. ...
Attach the chassis handles to the chassis. Four handles come in a box with the chassis. Align the slots on each handle with the posts on the side of the chassis and slide the handle up until it locks into place. Lift the chassis up, place the rear of the chassis onto the chassis rai...
Before you can ground the chassis, you must have a connection to the earth ground for the data center building. If you installed the Cisco Nexus 7018 chassis into a bonded rack (see the rack manufacturer’s instructions for more informatio...
The Cisco Physical Access Gateway (Figure 2-1) is installed near each door to provide access control and connections for card readers, door locks and other input and output devices. The Gateway is connected to the Cisco Physical Access Manager using an Ethernet connect...
When the identify LED turns on solid, slide the drive all the way into the system or an expansion unit, and push the drive handle(A)in until it locks. SeeFigure 1. Figure 1. Installing the disk drive in the system On the console, press Enter to indicat...
Install or close the system, expansion unit, or rack front door. If the system power cables were removed, reconnect them. Start the system or logical partition. For instructions, seeStarting the system or logical partition. To configure the newly installed disk drive or solid-state drive, see...
b. Pull the mounting bracket out until it locks in the extended position. c. Slide the mounting bracket release button in the direction shown in FIGURE 2-13, and then slide the mounting bracket out of the slide rail. FIGURE 2-13 Sliding the Mounting Bracket Release Button ...