Automated installations use a Pre-boot eXecution Environment (PXE) technology to enable the clients without an operating system to boot remotely to the automated installation server that performs the installatio
Planning the Operating System Installation This chapter identifies the information you need to properly plan the installation of an operating system to a Sun Blade X6270 Server Module. This chapter contains the following topics: Supported Operating Systems Installation Prerequisites Installation Methods ...
Before installing the NTC, you need to configure the host name and IP address of the operating system of the NTC server according to the plan. Procedure Log in to the server through the management port as the root user. Run the following command to go to the YaST2 Control Center page: ...
· The operating system is installed on the logic disk of the storage controller. · BIOS NUMA is enabled and IMC0 and IMC1 for CPU 1 or CPU 2 are disabled. Solution To resolve the issue: 1. Do not disable all i...
Click[Install]⑪to begin the installation of the Windows operating system. Note: The installation process may take some time, depending on your device and USB drive performance.Ensure that your device is connected to a power source and do not force a shutdown during the installation to avoid...
not displace the system version of the Java platform suppled by the Solaris Operating System (unless you intentially install it in the same location as the system's Java platform, which requires you to be root user). If you are using this file, seeInstallation of Self-Extracting Binarybelow...
Note: An over-the-network installation shall not be used for the Evaluated Configuration, as it requires the use of an existing operating system such as Windows 9x, Windows Me, Windows NT, or MS-DOS.The setup boot disk installation method requires the use of four setup floppy disks. The ...
If the user provides the operating system, perform the following steps to check and change the number of operating system handles: Log in to the eSight server as the root user. Run the following command to view the number of operating system handles: # ulimit -n Open the l...
Remote OS Installation uses the new Pre-Boot eXecution Environment (PXE) DHCP-based remote boot technology to initiate the installation of an operating system from a remote source to a client hard disk. The remote source—a server that supports Remote Installation Services (RIS)—provides the netw...
operating_system The type of Linux installed on the server (red_hat or suse). For example: # cd /mnt/dvdrom/drivers/linux/red_hat Note - If you have OEL installed on the server, use the drivers in the red_hat directory. 3. Run the following command to install the drivers: ...