Now that the right side cup has been fitted we can install the axle. Remember to insert it in the correct way so that the longer side exits the right side cup you just fitted. You can see the small black dot I used to mark the longer end. Right side bottom bracket cup and axle fi...
Make sure that the front road wheels are in a straight ahead position. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install). Disconnect 12V power. See Disconnect 12V Power. Remove the front wheels. Wheels - Axle Set (Remove and Install). Remove the HV battery...
Insert the axle again using the above procedure. Keep the wheel away from the car body until the glue dries.6. Check that the axle went in straight by checking the wheel angle from the front or back of the car. The wheel should be perpendicular to the car body. Repeat for the ...
To re-install the rear wheel, first place the chain back onto the smallest sprocket, and then slide the axle evenly up into the rear dropouts. Tighten the quick release lever the same way as the front wheel, with the lever on the left side of the bike. Make sure the lever is safely ...
install a Powertrax No-Slip in the rear, run it for a little while, then when funds and time are available, swap in lower gears, drop the Detroit Locker that was up on the shelf into the rear axle and move the Powertrax No-Slip up to the front Dana 44. Sounded like a good plan...
As a hardcore off-road vehicle, masculinity is essential. The design style of the new generation Ford Bronco is still tough, and the silhouette of the whole vehicle is almost entirely composed of straight lines, which looks angular, very tough. The classic round headlights of the Bronco family...
Start at the front; shake, rotate and tap the pipes into place. Remember, the pipes are hung from rubber--they'll need some clearance to account for normal motion. One very important thing: Be sure the tips center on the exhaust cutouts, and that each one sticks out the same distance...
The straight end connects to the stainless fitting; the bent end will run into the trunk. The long line will run up to the ACD, the two shorter lines will run to ...
Place the front end of the exhaust pipe on top of the jack’s arm and carefully raise it up so it doesn’t fall. Keep lifting the exhaust system until the end of the pipe lines up with the port on the downpipe, which comes down from the engine and connects to the entire system.[...