In Git 1.7.0 or later, to cancel a conflicting merge, usegit reset --merge.Warning: In older versions of Git, runninggit pullwith uncommitted changes is discouraged: while possible, it leaves you in a state that may be hard to back out of in the case of a conflict. ...
In Git 1.7.0 or later, to cancel a conflicting merge, usegit reset --merge.Warning: In older versions of Git, runninggit pullwith uncommitted changes is discouraged: while possible, it leaves you in a state that may be hard to back out of in the case of a conflict. ...
To use branching and merging in Git, you first need to learn about the commands that are built into Git to create a branch. The command is branch followed with a name for the new branch.git branch <branchname>When you execute the branch command, it (by default) uses the pointer of ...
It is not needed if you run AIO behind a web server or reverse proxy and can get removed in that case as you can simply use port 8080 for the AIO interface then. --volume nextcloud_aio_mastercontainer:/mnt/docker-aio-config This means that the files that are created by the master...
This was already suggested ingitlab-foss#56632 (closed), which was marked as a duplicate of#29654 (closed). But it is obvious the latter doesn't address this issue, as discussed from#29654 (comment 281772280). The particular use case is: ...
Case 1: The email address set in the git config does not match the email address in Bitbucket: Suppose your email address specified on your git configuration file does not match the email address specified in your Bitbucket user profile. In that case,...
(use "git merge --abort" to abort the merge) Unmerged paths: (use "git add <file>..." to mark resolution) both modified: merge.txt The key point in this output is theunmerged pathssection, which lists files with conflicts, such asmerge.txtin this case. ...
$ git checkout -b <branch> --track <remote>/<branch> You could omit <branch>, in which case the command degenerates to "check out the current branch", which is a glorified no-op with a rather expensive side-effects to show only the tracking information, if exists, for the current ...
It then creates a new commit that reverts the changes. To use the git revert command, you first need the ID for that commit. You can get this with the git log command. Here, the command is used with the --oneline option to make each commit display on a single line: git log --...
In Git 1.7.0 or later, to cancel a conflicting merge, usegit reset --merge.Warning: In older versions of Git, runninggit pullwith uncommitted changes is discouraged: while possible, it leaves you in a state that may be hard to back out of in the case of a conflict. ...