RX packets:56103 errors:0 dropped:0 overruns:0 frame:0 TX packets:56103 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:5079451 (4.8 MiB) TX bytes:5079451 (4.8 MiB) 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 说明: eth0表示第...
ifconfig reports dropped packets or frames for an interface while ethtool statistics show none 决议 The ethtool statistics should be favoured over those of ifconfig. The dropped counter in ifconfig was origi...
ifconfigreports dropped packets or frames for an interface whileethtoolstatistics show none Resolution Theethtoolstatistics should be favoured over those ofifconfig. Thedroppedcounter inifconfigwas originally intended to log protocol-only drops, such as a protocol handler being unable to allocate memory...
Beginning with kernel 2.6.37, it has been changed the meaning of dropped packet count. Before, dropped packets was most likely due to an error. Now, the rx_dropped counter shows statistics for dropped frames because of: Softnet backlog full -- (Measured from /proc/net/softnet_stat) ...
Beginning with kernel 2.6.37, it has been changed the meaning of dropped packet count. Before, dropped packets was most likely due to an error. Now, the rx_dropped counter shows statistics for dropped frames because of:Softnet backlog full -- (Measured from /proc/net/softnet_stat)Bad / ...
dropped 接收时丢弃的数据包数 overruns: 接收时由于 buffer 溢出而丢弃的数据包数 frame: 接收时由于 frame 错位而丢弃的数据包数 TX packets 发送的数据包数 errors: 发送时错误的数据包数 dropped: 发送时丢弃的数据包数 overruns: 发送时由于 buffer 溢出而丢弃的数据包数 carrier: 发送时由于 carrier 错误而...
G 了一下,发现这些 errors, dropped, overruns 表示的含义还不大一样。根据这篇文档的解释: # ifconfig em2 em2 Link encap:Ethernet HWaddr AC:85:3D:A9:03:0D inet addr:211.211.211.211Bcast:211.211.211.255Mask:255.255.255.0UP BROADCAST RUNNING MULTICAST MTU:1500Metric:1RX packets:17141208886errors:...
RX packets:3669 errors:0 dropped:0 overruns:0 frame:0 TX packets:2892 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:667547 (651.9 KiB) TX bytes:584799 (571.0 KiB) Interrupt:209 Memory:fb000000-0 eth0:0 Link encap:Ethernet HWaddr 00:0F:EA:A3:06:A2 ...
packets代表包数量、errors代表包发生错误的数量、dropped代表包由于有问题而遭丢弃的数量 TX:代表网络启动到目前为止数据包发送数量 collisions:代表数据包冲突的情况,如果发生太多次,表示你的网络状况不太好 txqueuelen:代表用来传输数据的缓冲区的存储长度RXbytes、TXbytes:接收、发送字节数量 ...
RX:网络由启动到目前为止的数据包接收情况,packets代表数据包数量、errors代表数据包发生错误的数量、dropped代表数据包由于有问题而遭丢弃的数量等 TX:与RX相反,网路由启动到目前为止的数据包发送情况 collisions:代表数据包冲突的情况,如果发生太多次,表示你的网络状况不太好 ...