Molecular weight: 98.07 Density: 1.84 g/cm³, Melting point: 10 °C, Molar mass: 98.079 g/mol, IUPAC ID: Sulfuric Acid, Boiling point: 337 °C, Classification: Sulfuric Acids CAS No.: 7664-93-9;8014-95-7;17107-61-8;12772-98-4 EC No.: 231-639-5 Product ...
ChemInform Abstract: MOLAR VOLUME OF HYDROCHLORIC ACID IN AQUEOUS DIOXANEgases, liquids, superfluidityNo abstract is available for this article.doi:10.1002/chin.197904012R. L. BOKHRAS. K. AGARWALWILEY‐VCH Verlag GmbHChemischer Informationsdienst
The molar absorb... L Svennerholm - 《Biochim Biophys Acta》 被引量: 4139发表: 1957年 Alcoholic hydrochloric acid-carmine as a stain for chromosomes in squash preparations. A regressive bulk carmine staining schedule was adapted from a formula proposed by P. Mayer. The stain is made by ...
Hydrochloric acid (HCl) is a common acid used in the laboratory to make acidic solutions. Aqueous HCl solutions show low pH values because HCl is a strong acidic compound. You can easily check this by using a pH meter. In theoretically, pH value can be found by substituting concentration ...
Furosemide (4-chloro-2-furan-2-ylmethylamino-5-sulfamoylbenzoic acid) was examined as an inhibitor for the corrosion of carbon steel (CS) in 1.0 M HCl. The investigation included mass loss (ML) and electrochemical techniques: potentiodynamic polarization (PP), electrochemical impedance spectroscopy ...
Figure4illustrates the WL over time for CS in one molar HCl, comparing situations with varying concentrations of the diolefinic dye at 298 K. These WL curves exhibit an initial rapid increase. The presence of the additive results in lower weight loss compared to the free acid situation, indica...
Electrochemical, surface analysis, and theoretical investigation of 3-hydroxy-5-(phenylamino)-4-(p-tolyldiazenyl)thiophen-2-yl)(phenyl)methanone as a corrosion inhibitor for carbon steel in a molar hydrochloric acid solution Int. J. Electrochem. Sci., 18 (4) (2023), Article 100070 View PDFVi...
It was found that the corrosion protecttion efficiency of the PAA – adsorbed layers strongly depends on both the molar concentration of PAA in the solution and its molecular weight, reaching limiting values between 85 and 96 %. Simultaneously, it was also concluded that a relatively high ...
It was found that the corrosion protecttion efficiency of the PAA – adsorbed layers strongly depends on both the molar concentration of PAA in the solution and its molecular weight, reaching limiting values between 85 and 96 %. Simultaneously, it was also concluded that a relatively high ...
molar hydrochloric acid (4Z)-4-(2H-1,4-benzothiazin-3(4H)-ylidene)-5-methyl-2- phenyl-2,4-dihydro-3H-pyrazol-3-one (P1) (4Z)-4-(2H-1,4-benzothiazin-3(4H)-ylidene)-5-methyl-2- phenyl-2,4-dihydro-3H-pyrazol-3-one corrosion inhibitors corrosion inhibitor 0...