You can run the qos pre-classify command on the outbound interface to allow packets to carry the private IP addresses before NAT to the outbound interface. Traffic classification then can be performed based on private IP addresses. Forwarding rule Matching Rule Command All packets if-match ...
Configure the QoS function for A2A VPN. Run qos pre-classify The device is configured to pre-extract original packet information. By default, the device does not pre-extract original packet information. Run qos group qos-group-value A QoS group is configured for A2A VPN packets. By default,...
QoS resource scheduling can set the upper limit of resources usable by FWA. The toC service experience can be ensured using priority-based scheduling during congestion. Given the limited air interface capabilities, the essence of this solution is to allocate resources appropriately and achieve basic ...
[r1-GigabitEthernet0/0/0]ip address 12.1.1.1 24 1. 2. 配置RIP协议: [r1]rip 1 [r1-rip-1]version 2 [r1-rip-1]network 12.0.0.0 [r2]rip 1 [r2-rip-1]version 2 [r2-rip-1]network 12.0.0.0 [r2-rip-1]network 23.0.0.0 [r3]rip 1 [r3-rip-1]version 2 [r3-rip-1]network 23.0...
Qos pre-classify: Disable Proposal name:tran1 Inbound AH setting: AH SPI: AH string-key: AH authentication hex key: Inbound ESP setting: ESP SPI: 12345 (0x3039) ESP string-key: aUUOJ`$]T*KQ=^Q`MAF4<1!! ESP encryption hex key: ...
Run qos group qos-group-value The QoS group to which the IPSec packets belong is set. By default, no QoS group to which the IPSec packets belong is set. Run qos pre-classify Pre-extraction of original IP packets is enabled. By default, pre-extraction of original IP packets is disabled....
Qos pre-classify : Disable [Outbound ESP SAs] SPI: 1823851704 (0x6cb5c4b8) Proposal: ESP-ENCRYPT-3DES-192 ESP-AUTH-MD5 SA remaining key duration (bytes/sec): 1887436800/3586 Max sent sequence-number: 0 UDP encapsulation used for NAT traversal: N ...
192.168.1.0/255.255.255.0 0/0 Qos pre-classify : Disable Qos group : - [Outbound ESP SAs] SPI: 437762941 (0x1a17bb7d) Proposal: ESP-ENCRYPT-AES-128 SHA2-256-128 SA remaining key duration (bytes/sec): 1887436800/3575 Max sent sequence-number: 0 UDP encapsulation used for NAT traversal...
To use an ACL in a traffic classifier to match the source IP address, run the qos pre-nat command on an interface to configure NAT pre-classification. NAT pre-classification enables the NAT-enabled device to carry the private IP address before translation on the outbound interface so that the...
(QoS ID) is allocated by a control plane network element CP of the sending device in initiating a process of an attachment request or a session creation request. After receiving the QoS ID, a user plane network element UP sets up a correspondence between the QoS ID and a Traffic Flow ...