When the PSK is used for DTLS encryption, this command can be used to modify the PSK value in the DTLS session. Follow-up Procedure Run the capwap dtls control-link encrypt command to enable DTLS encryption for CAPWAP control tunnels. Alternatively, run the capwap dtls data-link encrypt ...
When a pre-shared key is used for DTLS encryption, you can use the capwap dtls psk command to change the pre-shared key. It is recommended that you change the pre-shared key in a timely manner to ensure device security. Follow-up Procedure Run the capwap dtls control-link encrypt ...
A leader AP supports direct (bridge) and tunnel (tunnel) forwarding modes, depending on whether service packets are transmitted over CAPWAP tunnels. STAs can roam between Fit APs. Differences between a leader AP and a WAC: A leader AP also serves as a Fit AP and is used to build aWLANto...
CAPWAP, tag/terminal location, and spectrum analysis iPCACollection of real-time statistics on the number of lost packets and packet loss ratio at network and device levels Super Virtual Fabric (SVF)Functions as the parent node to virtualize downstream switches and APs vertically as one device for...
Run: The CAPWAP link is properly established. Config: The AP obtains the configuration delivered from the AC. The general AP join process can be outlined based on the changes of the CAPWAP states: Idle (not marked in the figure) The AP is started properly. After the initialization is comple...
The access device adds the management VLAN tag to CAPWAP packets. NOTE: In this case, to enable CAPWAP packets to carry the management VLAN tag, run the vlan pvid vlan-id command to configure the PVID of the AP's uplink wired interface to be the same as the management VLAN ID. ...
After DTLS encryption is configured for a CAPWAP control tunnel, packets exchanged over the tunnel are encrypted using DTLS on both ends of the tunnel. This ensures packet integrity and privacy. DTLS allows a client and a server to establish a session by performing a handshake. During the ...
Run: The CAPWAP link is properly established. Config: The AP obtains the configuration delivered from the AC. The general AP join process can be outlined based on the changes of the CAPWAP states: Idle (not marked in the figure) The AP is started properly. After the initialization is comple...
configure the parametervlan-replaceto enable the VLAN replacement function so that the VLANs carried in packets of Fit APs are replaced with the VLAN used by the CAPWAP source interface. If PPPoE dial-up is not configured on the leader AP, do not enable the VLAN replacement function in case...
When the CAPWAP link between an AP and AC is disconnected, this function enables the AP to maintain the Mesh link. The specific procedure varies depending on the AP role: MPP: maintains all Mesh links, ensuring normal links between the MPs and the uplink network. MP: maintains all Mesh ...