The HTTP status code 200 means that the request has been received for processing. This indicates that the operation finished successfully.The complete set of status codes that the service might return is listed in the following table:展开表 ...
The HTTP status code 200 means that the request has been received for processing. This indicates that the operation finished successfully.The complete set of status codes that the service might return is listed in the following table:展開資料表 ...
Typically, this HTTP status code means that the number of incoming concurrent requests exceeds the number that the IIS web application can process. This problem may occur when the performance configuration settings are set too low, the hardware is insufficient, or a bottleneck occurs in t...
100 — Continue: This interim status code means the server received the initial request, and the client should continue. 101 — Switching protocols: This code is a response to an Upgrade header field request and states the protocol the server will switch to. 102 — Processing: This response ...
306 “Switch Proxy”– This code is no longer in use. It means that the following requests should use the specified proxy. 307 “Temporary redirect”– This is the new code for temporary redirects that replaced the HTTP 302 code. It specifies that the requested resource has moved to another...
The Hypertext Transfer Protocol Stack (Http.sys) file blocks IIS from processing the request because of a problem in the request. Typically, this HTTP status code means that the request contains invalid characters or sequences, or that the request goes against the security settings in theHttp.sy...
The Hypertext Transfer Protocol Stack (Http.sys) file blocks IIS from processing the request because of a problem in the request. Typically, this HTTP status code means that the request contains invalid characters or sequences, or that the request goes against the security settings in theHttp.sy...
HttpWebRequest delegates are always called on a new non-UI thread, which means that if you plan to use the response in the UI, you will have to invoke back to the UI thread. You can do this by retrieving the current SynchronizationContext. The following code example demonstrates the ...
HttpWebRequest delegates are always called on a new non-UI thread, which means that if you plan to use the response in the UI, you will have to invoke back to the UI thread. You can do this by retrieving the current SynchronizationContext. The following code example demonstrates the ...
The response code is 200 if the channel exists, and 404 otherwise:> curl --request POST --data "test message" http://127.0.0.2:80/pub ... > curl -v --request GET -H "Accept: text/json" http://127.0.0.2:80/pub {"messages": 1, "requested": 7, "subscribers": 0, "last_...