Enter configuration commands, one per line. End with CNTL/Z. RTR-01(config)# RTR-01(config)#interface gigabitEthernet 0/0 RTR-01(config-if)#ip address 103.21.40.2 255.255.255.252 RTR-01(config-if)#no shutdown RTR-01(config-if)#exit RTR-01(config)# RTR-02#configure terminal Enter conf...
Enter configuration commands, one per line. End with CNTL/Z. Router1(config)#interface FastEthernet 0/1 Router1(config-if)#ip address 172.22.1.3 255.255.255.0 Router1(config-if)#standby 1 ip 172.22.1.1 Router1(config-if)#standby 1 priority 120 Router1(config-if)#exit Router1(config)#end...
Ping, traceroute and arp commands issued on Laptop0 confirms that the configuration is working. The IP packets are transiting through Router0 (192.168.1.2) HSRP configuration using Cisco catalyst 3560 and 3650 switches HSRP can be configured in the same way in Cisco catalyst 3560 and 3650 multil...
Wait for a few seconds, and run both commands on the PC again. If the PC can still access theServer, it verifies that the HSRP configuration is working properly. It also verifies that the failed gateway router has been replaced by the standby router. Now power on the switch's interface ...
Cisco HSRP配置 网络拓扑 配置命令 HA-A配置命令 HA-A>enable HA-A#conf terminal Enter configuration commands, one per line. End withCNTL/Z. HA-A(config)#int gigabitEthernet 0/2 HA-A(config-if)#no switchport[周书轩1] HA-A(config-if)#ip address 192.168.30.2 255.255.255.0[周书轩2] ...
Enter configuration commands,one per line.EndwithCNTL/Z.Router(config)#HR2R2(config)#int f0/0R2(config-if)#ip add192.168.1.252255.255.255.0R2(config-if)#no shutR2(config-if)#int f0/1R2(config-if)#ip add100.1.1.1255.255.255.0R2(config-if)#no shutR2(config-if)#exitR2(config)#ip ro...
(Optional)authenticationstring—Enter a string to be carried in all HSRP messages. The authentication string can be up to eight characters in length; the default string iscisco. (Optional)group-number—The group number to which the command applies. ...
This configuration overrides and MAC reservation is assigned.Enable Virtual MAC reservation with below configuration commands: Procedure Step 1 switch# configure terminal Enters global configuration mode. Step 2 switch...
As suggested by other experts here, please type the output of the commands and we should be able to check it. Also run a debug as well so that we can if the FSM of HSRP is changing states etc. I mean it goes from standby-> speak--> Active etc..it would be good to see that ...
Enter configuration commands, one per line. End with CNTL/Z. SW1(config)#spanning-tree vlan 1 root primary SW1(config)#exit //用root primary 自动降低优先级为4096的倍数,作为根交换机 === EtherChannel 以太通道 将物理链路捆绑在一起,使之看起来是一条链路 作用: 提高...