Then, take a dish detergent with grease-attacking properties and apply it to the back of the stain. Next, flip the garment over to stain side up. Carefully scrub the area using a clean toothbrush. Do not rinse the piece. Instead, put it in the washing machine on the ...
Some staining substances, such as candle wax and gum, can be hardened by the application of cold so that they are easier to remove. Work fast when treating a spill that is still semisolid. You may be able to limit the area stained by quickly hardening the staining material. To freeze a...
Get tips on grip waxing your classic cross-country skis and learn how to use hard waxes, klister waxes and spray waxes.
Place the iron on the ski or snowboard base and spread the wax over the entire base until a layer of wax coats the whole surface. Don't hold the iron in one place for too long, as this could cause the base to blister. Make sure that the wax melts all the way across the ski or ...
Scrape off as much wax as you can with a butter knife or spoon when it’s dry. You can also freeze the clothing item to harden the wax. Be sure not to try to remove the wax when it’s still warm, as this may cause it to spread into the fabric. ...
Install the wax seal or gasket of the new toilet according to the manufacturer's instructions. (Hardware and fittings are usually included with the toilet.) Install the offset collar/adapter of the new toilet to the closet flange, the fitting that connects to the drain line. Put the toilet ...
To remove wax from tabletops, heat pooled wax with a blow dryer on the lowest setting for several seconds, then scrape it off using a credit card, plastic spatula, or flexible dough scraper (don't use anything made of metal). You should be able to buff the excess away with a soft cl...
Take your bar of wax and touch it to the iron. It should melt readily, but it shouldn’t run quickly off the edge of the iron. Melt the end of the wax and rub it on the board, dispersing it around the entire surface. As the tip of the wax cools, continue to touch it to the...
Take a knife that is sharp enough to do some damage to the wax, but not so sharp that it risks damaging the item of clothing. Take care when handling the knife; always use strokes going away from your body to avoid any accidents. Work on the wax to remove as much of the hardened ...
board level, locks them into place, and supports the tips and tails, but it can also be done with blocks of wood to elevate and support the tips and tails. It’s very difficult not to drip some wax off the skis, so if the surface below you needs protection, cover it before you ...