Instead, designers have the option to split parts during part creation. Essentially, the part generates across multiple sections (defined by the user), and the user assigns pins per standard part creation. It’s up to the user to decide how they wish to distribute the pins in a way that ...
Any advice would be appreciated. The reason I want to transfer OrCAD schematics to Protel, is that I want to use OrCAD for doing the simulations, and Protel for the PCB development (for me the simulation capabilities in Protel are inadequate). This has been discussed in some detail on the ...
In addition, see the CX3 RDK Schematics for a complete example. The MIPI CSI-2 controller can be configured for one to four data lanes, different data formats (such as RAW, YUV, or MJPEG), and different camera resolutions. See CX3 firmware for...
In the center of the PCB you can see the 1k POT mod across the Thermistor. Back-side of S-350 PCB. Allow me to state that Visio is a flimsy bit of software for creating schematics; I miss the days of OrCAD, PADS, heck even AutoCAD could do a better job. But itââ‚...