static domain_name_servers=1.1.1.1Copy 3. Save & exit by using CTRL + X, then Y, then the ENTER key. 4. Now reboot your Pi by entering the following command. sudo rebootCopy 5. Go to ipleak.net and check that your DNS is no longer leaking. If you’re still leaking, then you ...
You should be now connected to theVPN serveryou personally configured on your RPi. The OpenVPN Connect client will show you some useful information such as your sent and received traffic, connection duration, and the time you received the last packet. If for some reason you can’t connect to...
for the RPi. The script has been updated to hopefully make the transition as easy as possible. To update to the new driver run the script and it will end by running rpi-update which should load the latest kernel version with the new driver included. The script will then reconfigure the i...
running and actively accepting connections on that port for it to give me an "open" result, so I want to make sure I have things set up correctly. The main place I can see a potential for a mistake is when editing server.conf, I plug my public IP in in place of -PI-LAN-IP, ...
cyw43_arch_lwip_end(); #endif ... static void udpReceiveCallback( void *_arg, struct udp_pcb *_pcb, struct pbuf *_p, const ip_addr_t *_addr, uint16_t _port) { char *_pData = (char *)_p->payload; ... do stuff... pbuf_free(_p); // don't forget to release the bu...
In the “IPv4 Configuration Type” select “Static IPv4”. You will see a “Static IPv4 configuration” be shown at the bottom of the page. Enter the IP address of the interface. Typically “.1” is used for the last octet to indicate an interface/gateway IP address (similar to how ...
Recommend setting a static IP address in /etc/dhcpcd.conf for stability Configure WiFi country to avoid legal issues when using a wireless dongle Increase swapfile size for memory intensive tasks like building code Enable SSH login by default for easy remote access on first boot Set hostname to...
DNS-01 challenge is used to verify ownership for the domain. This means that HTTP-01 challenges cannot be used with this method, meaning that youmustbe using a DNS service that gives you control over your DNS records, or an API plugin to allow for DNS challenges. Certbot have publisheda ...
Cluster controller uses eth1 to get its own NATed IP address from the router/DHCP server (which in turn gets it from the cable modem.) Cluster controller uses eth0 (static address 10.11.12.1) to be connected to internal network via switch or router. eth0 is also the net device...
I've also added a "Why" section in Reply #6 for those wanting a deeper understanding of why all this is necessary.You should do the following: Configure the FPP wlan0 interface to a static IP address including the gateway and DNS servers. In most cases, the gateway and DNS server are...