You can see in the image above I appear to be using theUSER:100000projection (the note in the bottom right-hand corner). QGIS didn’t know what to name the NY State Plane projection when I imported the shapefile, so it gave us that confusing result. What if it’s wrong!!! We’re ...
I'm quite familiar with QGIS in general, as well as mapshaper and one of my old school favorites ShapeToTab (https://community.tableau.com/s/question/0D54T00000C5QbK/map-utility-downloads - you know, how we used to make maps before spatial files could be used in T...
It also can reproject grids on the fly to match loaded rasters. So, I think these should be applied into the repo. I was not able to open a very large grid (2GB+), it failed in DotSpatial.Data.PyramidImage.WriteWindow function as shown below: I suppose that's a different issue....
I went back to the older scripting and was able to make it work with your guidance. Thank you very much. I realize what you did a few posts earlier in changing the linestring z geometry so that it is not flat. I like the way this turned out, except the contour lines I have made...
GOES-16 is a geostationary satellite and the data is given in a geostationary projection. I'm ultimately trying to get the latitude and longitude of each pixel in GOES-16 satellite data, and then reproject the data on other maps with Lambert Conformal Conic or Equidistant Cylindrical projections...