, against the grain, with a drill or a brace and bit. Drill completely through the damaged block, but not into the subfloor under it. Then, with a sharp chisel and a hammer, carefully split the block and pry up the pieces. Make sure you don't damage the surrounding pieces of wood....
Using the vacuum and tack cloth, make certain the floor is free of hair and dust. Then, apply the polyurethane with a smooth sponge roller (Image 1). You may need to use a paintbrush around the edges of the room. Work in small sections with the grain of the wood. Polyurethane requir...
Expert advice and videos on how to repair hardwood floor water damage, hardwood floor gouge repair, repairing a hardwood floor finish, fixing wood flooring scratches, and more
First, you’ll need to remove the linoleum from your wood floor. Start by removing any loose nails or screws from the floor. You can use a screwdriver or a utility knife to remove them. Once all of the nails and screws are removed, you can simply pull up on your linoleum and it sho...
Both tile and laminate flooring planks can be installed over wood or concrete subfloors. Since you must level either type of subfloor before laying tile, if you decide that you want to replace a tile floor with laminate flooring, you won’t need to do as
Solid hardwood floors are made from pieces of wood cut straight from a tree. For example, if you took solid pieces of oak, laid them next to each other, and then sanded it all smooth, those would be solid wood floors. It is the same time of wood all the way through the board. The...
RELATED:How to Choose the Type of Wood Flooring for Your Home When to Call in a Professional Sometimes water damage is too severe for DIY fixes. If you have antique furniture or pieces with sentimental value, it may be best to consult a professional furniture restorer. Professionals have acces...
Simply run it along the surface at a 15 to 30-degree angle, and replace the blade if it starts to dull while you’re working. If the laminate flooring you’re removing was attached to a wood subfloor, use an orbital sander to remove any remaining adhesive. Make sure you wear safety ...
Picture a typical wooden floor plank. If the edges along the entire length of the plank curl up and the middle sinks down, that's cupping. This is caused by a moisture imbalance, specifically when there is more moisture on the bottom of the wood pieces than on the top. For example, ...
After you remove the old carpet, you need to sand the floor to make sure it’s smooth and level. Then you can apply stain and a polyurethane finish to protect the wood. If the wood is scratched, you can buff it to smooth it out even more. When you’re finished, your room will ...