Glue (loctite super glue-3). Sandpaper. Remove red cap. Stick a stem to trackpoint pointer base with double side tape. Insert trackpoint with stem into hole. Close case, flip keyboard, screw on stem ball, test. Rinse and repeat for other stems until satisfied with length. Remove double ...
Blue Loctite 2P-10 Heat shrink tubeCut off the damaged AUX cable, leaving as much wire remaining as possible. Cut the damaged AUX cable as near to the base as possible. (From: Youtube/Joe’s Gaming & Electronics) Carefully remove the outer layer of the cord (about ¾’s of an inc...
Break loose the six 6mm hex head bolts from the crankshaft pulley, but don't remove. These bolts like to strip out from the socket, so ensure the Allen head socket is in good shape, then is completely engaged into the bolt head before loosening them. These bolts may be tight enough yo...
If you’re using ordinary screws, be sure to get someLoctite (thread locker). Opt for the blue liquid type, as the red liquid type is designed for permanent use and can make removing the screws later quite difficult. Lastly, ensure the motor screws aren’t too long and touching the moto...
Clean and paint the bar with red oxide. Hold the bar where you want it ensuring it's level and mark holes for the drill points. Remove the bar and drill the marks 3 1/2 inch - 4 inch (same length as thread on the bolts. Use a 9 mm drill bit even though it's a 10 mm bolt...
Any reason why Celestron has to loctite (probably uses red instead of blue) these set screws that hold the encoder!? Here so many Folks having to drill out these screws. Its not like the encoders are subjected to a ton of force or weight upon them. I was lucky that...
Glue (loctite super glue-3). Sandpaper. Remove red cap. Stick a stem to trackpoint pointer base with double side tape. Insert trackpoint with stem into hole. Close case, flip keyboard, screw on stem ball, test. Rinse and repeat for other stems until satisfied with length. Remove double ...