Pressing the“ERASE”button on the scan tool to remove the error code. The Check Engine Light will turn off if all error codes are cleared. Some scan tools have many capabilities such as freeze frame that notes some sensor readings when a code was set and removing the codes will also remo...
The simplest and safest way to turn off the check engine light is by using an OBD II Trouble Code Scan Tool. You may buy a scan tool at your local auto parts store. It can be used to retrieve stored trouble code(s), clear trouble code(s) and turn off the check engine light, read...
you have a bad spark plug wire and it is causing an engine miss, and sets the check engine light. This misfire can also cause the oxygen senor to over compensate (due to the miss) and go haywire which sets an oxygen sensor failure code AND the original engine misfire...
The check engine light on a Chrysler illuminates when the engine experiences trouble and triggers an error code stored within the computer. It's inadvisable to reset the check engine light if the underlying problem hasn't been addressed. If you do, the light will simply come back on. Retriev...
The check engine light on a Toyota Camry comes on when there is a problem with the vehicle's emissions control system. Because there are a variety of sensors related to the emissions system, you will need to have a full diagnostic scan run on your Camry to figure out what the problem is...
A. Use Windows, Mac or Linux to reset the Check Engine Light To reset the Check Engine Light with your computer: Click theClear the DTCsbutton in theTrouble Codesview. Read and acknowledge the information presented. Now, the reset command is send to the car and the light is cleared. To...
Here's how the Check Engine Light works. When the OBD II system detects any fault that may cause an increase in emissions, it sets a "pending code" in the computer's memory. The Check Engine Light does not come on yet because the system needs to make sure the problem is real and no...
To reset the check engine light on a Polaris Ranger, you will need to locate the diagnostic connector. This is a black connector located under the dash on the drivers side. Connect a jumper wire to the connector and ground it, then use the ignition key.
If the check engine light comes on, one or more of some 10,000 DTCs might be stored in ECM memory. While the DTC doesnottell an auto repair technician what to replace, it can lead them in the right direction to make a repair. Once repairs are completed, the technician clears or “re...
The check engine light is perhaps one of the most dreaded warning symbols that can illuminate on the dashboard of Nissan Skyline. In this article, we will...