Place a bucket under the old drain trap to catch any water. Loosen the slip nuts holding the curved trap bend to the sink tailpiece and the trap arm, using tongue-and-groove pliers. The trap bend should slide off fairly easily, though you may need to wiggle it slightly to loosen it. ...
31/43 – Time to plumb the waterfall! Put your pump on a rock to lift it off the floor of your bottom tier. Your pipes should be snug to the floor and walls at each tier. 32/43 – A closer look at the plumbing. We cut a chunk out of the side of our filter pond and used...
Use a pair oftongue-and-groove pliersto loosen the slip nut that attaches the sink trap to the main drain line coming from the wall. Loosen the nut without disconnecting the sink trap.Disconnect the sink trap from the draincoming from the sink by loosening the slip nut connector. Pull down...
Next grind down the portion of rib that is glued to the baseplate so that it will form a sloped line going from the ½” tall height of the rib to the center ¼” tall strip (editor’s note: its easier to layout the rib patterns with this slope in mind and save the grinding)....
My rainwater tank array made from recycled plastic drums, 1300 litres capacity Rainwater is a valuable resource that is largely under-utilised in urban environments. It’s one of nature’s free resources that we can use to grow food, and considering that
HOW TO USE THIS CATALOG There are 51 basic carriers covered in this catalog: 3200-R-1500 3200-T-1814 3200-N-1860 3200-M-1885 3200-M-1547 3200-U-1815 3200-S-1865 3200-P-1888 3200-X-1558 3200-V-1816 3200-Z-1872 3200-R-1890 3200-L-1624 3200-W-1817 3200-A-1873 3200-D-1902 ...
If stud marks are printed on your Tyvek product, line them up with the first stud of your wall. The first roll should be plumb with the bottom edge of the wall. If the wall has not yet been raised, let the Tyvek overhang the bottom edge of the wall and fasten it there with Tyvek...