I want to paint an aluminum ladder to go in a swimming pool. What is the preferred treatment, paint, etc. I've been told that epoxy is too brittle, and the flexing of the ladder would make it "spider". It looks like at this point that chlorinated rubber would be my best bet. Any...
No matter which you choose, sanding is key to make sure the paint will adhere to the surface and also give you a very smooth finish for the paint. Start with 100 grit sandpaper and then finish off with 220. You do not have to go to the bare wood, just sand enough to knock down t...
Q. We had powder coated ADC12 High pressure die cast aluminium. We have done Alodine pre-coat; and after that pure polyester coating of 60 microns. But it is failing to sustain 336 hrs of salt spray test. Can anyone suggest alternate method for corrosion resistance to ADC-12?
monochromatic silver paint and silver powder-coated frame set off with yellow detailing, the lacing on both the seat and fuel tank which were indicative of Willie G’s fondness for the handmade look and his self-penned Fat Boy logo which was conceived to evoke ‘patriotism and nostalgia...
Moreover, a certain amount of heat is absorbed by interrupting the feedback of the heat to the fibers and, finally, the combustion process. Inorganic finishes containing phosphorus, boron, sol–gel precursors, nanoclay, and metal-based finishes, as well as carbon nanotubes and graphene, are ...
The things you use during the college years tend to be used for a few years at best, and not tend to be as nice as what you may have during your career. You may be used to your parent's house, which will have things they have accumulated over the years. But for now, you will ...
We know nothing about the coating except that it's black, and nothing about the tools, nor why you want to remove it, or how well it must be removed, or what condition the substrate must be left in, or what you will subsequently do to the tools (paint, powder coat, electroplate, ...
- Next, using rubber gloves⇦this oneBayorAmazon[affil links], apply a generous film of Jasco⇦this oneBayorAmazon[affil links]water based paint stripper, all over the surface. Wait 5 minutes and then re-strip with the putty knife. This should remove almost all of the residue. ...