Close the cold water inlet valve on top of the heater Open a hot water tap somewhere in your house near the heater Connect your drain hose Attach a garden hose to the drain valve at the bottom of the tank Place
Once complete, be sure to close the drain valve all the way and turn the water line back on, as well as the gas/electricity and the water heater itself. If you drained the tank completely, wait until it’s full again before turning the water heater back on. 成功完成!给作者 + 30 分...
Turn OFF the fuel source to your water heater (Electric: Turn off the circuit breaker / Gas: Turn the on/off control knob to off). Connect a garden hose to the drain valve, and OPEN the valve. OPEN a hot water faucet inside your house (leave open) to eliminate the negative pressure...
On-demand water heatersare easy to turn on, whether gas or electric. If it’s gas, you want the gas valve closed before you start. Flip the circuit, adjust the temperature, then open the gas valve. If it’s electric, simply flip the circuit, turn it on, and set the temperature to ...
Open a hot water tap nearest to the water heater, preferably on the floor above. This alleviates pressure in the system, allowing the water to drain quickly from the tank, much like removing your finger from the top of a drinking straw filled with liquid. 5. Open Drain Valve Open the ...
Install a shutoff valve at the dryer’s connections to the gas line if you have a natural-gas drying system. The dryer should then be unplugged and disconnected. Examine each component of the dryer — coils, wires, and so on. You can either repairs any visible damages or corrosion yoursel...
Install your faucet or toilet connector from the stop valve to your fixture. Hand-tighten the nut until snug, then using a wrench, tighten 1/4 in. turn. Be careful not to overtighten. Turn your stop valve to the open position, then open the main water supply. Check to see that th...
check that the water heater’s drain valve is closed and if not, close it. Next, fill the appliance with water by opening the valve that supplies the appliance.Do not restore power to the water heater until the appliance is completely filled with water; energizing the water heater while it...
Step 2: Attach a Hose to the Drain Valve Attach a hose to the drain valve and open the valve. At this point, we do NOT want to drain the tank, only to make sure that the drain valve is not clogged. If your tank is clogged, you'll need toaddress this issue first. ...
that will be exposed to these freezing temperatures and you know you won’t have to use them all winter, shut off the water supply in those pipes and drain them,” Wade says. Disconnect hoses from the pipes and leave the outside valve open in case there’s water left in the lines....