The“Name Server Lookup”(nslookup) command is a network administration command-line tool for querying and obtaining crucial mapping information between a domain name and an IP address. Also Read:DNS Toys: Daily use Tools and Utilities over the DNS Protocol Most of the modern Linux operating sys...
5) How to Find a Domain “CNAME Record” on Linux Using the nslookup Command Add thetype=cnamein the nslookup command to find CNAME record for a domain. $ nslookup -type=cname linuxtechnews.com 6) How to Lookup a Domain “SOA Record” on Linux Using the nslookup Command Add thetype...
In this article, you will learn how to install thedig commandandnslookup commandon Linux. These commands are used fornetwork troubleshootingand gathering information about domain names. Dig, short forDomain Information Gopher, is aDNS lookup utilityused for probing DNS servers and troubleshooting prob...
For example, if you’re sending data from Host A to Host B, as shown in Figure 9-1, your bytes leave the application layer on Host A and travel through the transport and network layers on Host A; then they go down to the physical medium, across the medium, and up again through the...
There are several ways to automatically configure networks in Linux-based systems. The most widely used option on desktops and notebooks is NetworkManager. Othe...
[ Readers also liked: Linux package management with YUM and RPM ] Finding the package The nslookup command is one that you use frequently but it isn't installed on any of the systems at your new job. You want to install it but you can't remember which package contains it and attempting...
To use innon-interactivemode typenslookup optionsat the command prompt. Using Nslookup To illustrate the use of nslookup we are going to use it to: Find the IP address of a host. Find the domain name of an IP address. Find mail servers for a domain. ...
nslookup -debug [domain-name] Note:In the interactive mode, setting thedebugoption turns on the debugging mode. To exit the mode, set thenodebugoption. Conclusion After reading this article, you should know how to install and use thenslookupcommand on Linux. The article provided examples of...
Use the nslookup Command Use the sd Command for Find and Replace on Linux Use tldr pages on Linux Using Cron to Schedule Tasks for Certain Times or Intervals Using Nano Text Editor Commands in Linux Using the JQ Command to Process JSON on the Command Line View Active Linux Processes Using ...
Open the Terminal on macOS and enter the following command to initiate an rDNS lookup for the IP8.8.8.8: dig -x 8.8.8.8 The output displays the domain name associated with the IP address. Like Linux, macOS also supports thehostandnslookupcommands for performing rDNS lookups. ...