Sand lightly along the grain of the wood, pressing the paper into cutout areas with your fingertips. Sand as far down into the carving as you can, but be careful not to flatten rounded surfaces. Crevices and Curved Edges Sand along crevices with a strip of sandpaper creased to fit into...
Heat yourironon low and turn off the steam. Lay a clean, thin sheet or other ironable material over the back of the poster and start ironing. Press the creased areas, always keeping the iron moving to avoid burn marks on the poster. 3. Check Your Progress Check your progress as you g...
Flatten the box by carefully disconnecting the connecting flaps at the bottom and inside the box. You may also use a craft knife for that. Use your scissors to cut off the flaps, as well as the inner flap and the short edge attached to it, so you are left with 3 sections: 2 cover ...
Flatten the end of the fan by folding the paper over. It'll give your fan a little more stability and strength, and the airflow will be much better. Staple or tape your handle so it doesn’t feel loose. The fan will still work perfectly, you just won't have to worry about it ...
Crease the top paper on the centerline of the model and fold back. See where you creased the center of the whole model a few steps ago. Use that as the line to fold back your top piece of paper, which you folded up in the last step. You will now have a long part of your model...
Finally, place the book inside the paper and run a glue stick along the creased border. Fold and press it to attach it to the book’s inside covers. Cut the slits in the paper so the spine is covered, but so there is no paper directly above or below it. Create four flaps by ...
When you have finished re-creasing, turn your paper so the open, uncreased side is facing in the downward direction (toward you) and: Fold the top flap, which should contain several layers of paper, to meet the top edge. Then turn your paper over and perform the same fold with the ...