entire area with new drywall. Long screws with washer heads are used to pull the drywall and old ceiling back up to the framing, or as close to level as possible. You end up with a drywall surface, but it eliminates the problems of sagging, cracking, and flaking plaster once and for ...
Option 4:If you don’t want to use sandpaper to prep your piece of furniture, you can use liquid sander deglosser. To get paint to adhere to wood, you usually have to sand it to provide some “tooth” for the paint to adhere, especially with anything that’s varnished or has a cle...
I think this will also lessen the likelihood of the drywall cracking along the seams or screw heads popping over time, which I see with most drywall jobs after a few years. If you can tell where the joints are, it’s not going to look like a plaster wall. Will anyone EVER notice ...
studs (no plastic on concrete). A vapor barrier is installed, then drywall. This situation is really bad, water vapor from the concrete escapes into the stud cavity and condenses on the back of the vapor barrier behind the drywall. Again, water creates a nasty mold situation in the stud ...
During the single digit temps and before hanging the drywall I pulled back the insulation to feel how well it was working and noticed iced had formed between the insulation and the block wall. Pulled all down let dry. Reinstalled with a 4mil sheet of plastic installed on the warm side of...
the of and to a in that is was he for it with as his on be at by i this had not are but from or have an they which one you were all her she there would their we him been has when who will no more if out so up said what its about than into them can only other time new...
Next mark the location of the bottom of the ledger board and install a small piece of z flashing. When I bolt the ledger board to the house, I like to install 3 or 4 flat washers between the house and the ledger to allow water and moisture to escape and not get trapped. I’d also...