Leaks coming from under the tank onto the toilet bowl or down back of toilet base usually indicate failed tank to bowl seals, either at the bolts or on the center drain. The tank to bowl gasket and toilet bolts with washers should be replaced. ...
hand-tighten until snug, then use your wrench to give alternating turns to each side until the unit is tightly in place. If the new bolts are too long for your bolt caps, the problem is once again easily resolved with a mini-hacksaw. Reattach the tank, and the toilet is ready to go...
The two pieces consist of a toilet bowl, which is the base unit that sits on the floor and a toilet tank. The toilet tank is mounted to the base unit with bolts. There is a large seal between the tank and the bowl. This seal is compressed by tightening the bolts that hold the two...
How to fix a running toilet: Here we explain how to diagnose and fix the cause of a running toilet. If you hear your toilet tank refilling when the toilet is not in use, or if there is always condensation on the toilet tank, you are wasting water and you may be ruining the septic ...
Use a shop vacuum to remove the standing water from the toilet. Unscrew the two bolts at the toilet's base, lift the toilet and slide it forward. Tip: Lift the toilet from the rear so any water still remaining will flow towards the front of the bowl instead of onto the floor. Most ...
How to Tighten a Toilet Seat While a wobbly seat is less problematic than an entire toilet that rocks, it’s still enough to give those who use it a somewhat insecure feeling. For this, the DIY fix couldn’t be much simpler. Just tighten the bolts that attach the seat to the toilet ...
The home improvement experts at HGTV show how to install a toilet. Tackle this DIY bathroom project with our step-by-step instructions.
or new washers for thetank-to-bowl bolts. If water is leaking from the tank to bowl gasket it will tend to leak more often when the toilet is flushed. If the water is leaking past the bolts and washers, the leak can often appear to be closer to thesidesof the toilet bowl, nearer ...
. This can cause the toilet to break or even over-siphon, which will cause water to flow out of the toilet bowl. If you notice that a toilet seat or lid is loose, tighten the mounting bolts. If a toilet handle or chain is loose, replace the chain or tighten the mounting bolts....
Install the new flush valve in its place, then tighten the flush valve nut and replace the tank-to-bowl gasket before putting the tank back into position. Secure the tank-to-bowl bolts and reconnect the water supply to the toilet. Turn the water back on and allow the tank to fill up....