Solved: I am trying to use the "Tools > tcl > Execute Macro" option in ModelSim to run a "testbench.do" script to run a
I would use scripting instead of the tcl console window in Quartus. Since you are using the ECO compilation flow, you can follow this Application Note on how to execute the .tcl scripts: https://www.intel.com/content/www/us/en/docs/programmable/683873/current/an-922-using-the-eco...
I wrote a script to change properties on all the symbols of my schematic. It works well except when the online drc is ON. With online drc active, the script becomes very slow. I have to turn off the online drc manually to avoid the problem. I tried...
can i resolve this issue? How can I execute the CLI cmdsvia TCL script? Regards 0 Helpful Reply Joe Clarke Cisco In response to Dipesh Patel -29-2013 08:09 AM Configure the following:event managersessioncli usernameUSER Where USER is a username authorized to run ...
Best way to execute TCL script on Router startup/reload Go to solution ilrobby00 Level 1 05-31-2017 03:16 PM Hi there! I've read a lot of posts about eem but, now, I'm really confused about which is the best way to execute a tcl script at router's boot/...
Solution: The following command closes waveform window in DO macro as well as in TCL: closedocument -wave The following command is supported only for the DO mode: close -wave In both cases, the waveform window has to be active to be closed. For detailed descriptions of both commands please...
The first step to getting started with Python is to install it on your machine. In this tutorial, you'll learn how to check which version of Python, if any, you have on your Windows, Mac, or Linux computer and the best way to install the most recent vers
I've succeed in sending ATA command to SATA drive ( device \\.\PhysicalDrive3 ) with iotcl command IOCTL_ATA_PASS_THROUGH_DIRECT .(device identified as an SCSI device )Now I would like to send ATA command to the same disk connected to USB port thanks to an USB/SATA Adapter ....
To run the script, follow the steps below: Open Vivado and create a project (if not existing yet) Open the TCL shell in Vivado Execute the command source <open-logic-root>/tools/vivado/import_sources.tcl Replace <open-logic-root> by the path of your Open Logic working copy. In case ...
To execute an FIL simulation over a USB Ethernet interface, perform one of the following workflows: • Open the FPGA-in-the-Loop Wizard and set FPGA-in-the-Loop Connection to USB Ethernet. • Open the HDL Workflow Advisor (requires HDL Coder). 1 In 1.1. Set Target Device and ...