Lower the blade for a 3/8-inch-deep cut. Pass the leg over the angled saw blade to cut a dado into its inside surface to accept the plywood bottom [3]. Make two or three passes, moving the fence each time, to create a 1/4-inch dado. Use a compass to mark a 3 3/4-inch ...
Either way, mark an X on the waste areas to avoid confusion when cutting them out. Cut the joints ¾ inch deep and 1½ inches wide with the dado set [7]. Assembly Open Gallery Glue arms to rear support: Spread a thin layer of glue on each joint, and clamp. Drill two evenly ...
A carpenter often has to make an angled crosscut on a board or a piece of molding. The cut almost always has to be accurate, because it's forming a corner joint for door casing, baseboard, a picture frame or some other structure, and a miscalculation can result in an unsightly gap. ...
We temporarily nailed some scrap wood to the top of the box in an angled pattern, using a 1/2 inch square dowel in between as a reference. Then we used our router to cut a channel through both sides of the box with a flush bit. You can also do this with a table saw, preferably ...