In Radio Settings, you’ll find options for setting up your radio’s display and audio etc. To configure radio settings, hold down theSYSbutton, it will take you to the TOOLS page. Press thePAGE>button twice to scroll to Radio Setup page. Here are the settings you might want to change...
Firmware is the backbone of any ESC; it’s the software that breathes life into these components, determining the range of settings you can tweak, the protocols it can communicate with, and the interface you’ll use to configure it. Each ESC firmware is only compatible to certain hardware. ...
It’s NOT compulsory to use DJI’s remote to control your drone, you can use whatever RC link you prefer, such as Frsky and Crossfire. But there is already receiver capability built into the DJI Air Unit, so you could save an additional receiver :) Totally up to you! Here is my rev...
When the drone has reached the launch point (or somewhere close depending on how accurate your GPS is), it will start to descend slowly, and when it touches the ground it will disarm automatically. This is like turning your FPV drone into a DJI drone when you lose signal or orientation.H...
Being able to change VTX settings remotely is so easy. It might not sound like a great deal, but once I tried it on my quads a few times, I was totally blown away by how convenient it is and I strongly recommend setting this up if your hardware supports. ...
The new FPort V2.0 is much more sophisticated, as it enables communications between the host device and multiple other devices, you can even update firmware to all the connected devices and configure them at the same time wirelessly from a radio with ACCESS protocol. ...