Flat tires frustrate everyone. Your first reaction might be to change the tire and have it repaired, but that might not be necessary. Your tire might just have a bad valve stem. The valve stem provides the means to fill the tire with air. If it fails, it can begin to leak, allowing ...
Grab the spare tire with both hands so that the valve stem (where you put air into the tire) faces you. Lift the tire and place it on the wheel hub, spinning the tire slowly to align the holes on the tire with the holes on the wheel hub. Retrieve the lug nuts from wherever you ...
How To: You may have already taken off your tire by now. But if you haven't, and you need some help, here is how to use a pair of tire levers. Insert one of the tire levers under the bead of the tire and pry it so that you can hook your tire lever to a spoke. Now that ...
To put the tire back on, the first thing you need to do is inflate the tube slightly (NOT FULLY) to give it some shape and get it to fit more easily. Then place it into the rim, positioning the valve stem through the valve hole. Make sure that the valve stem is correctly positione...
Valve Stem Tubeless valve stems feature rubber grommets and a knurled nut that seal the valve hole on both sides of the rim bed. Look for ones with removable cores; this allows a low-mess way to add sealant. The rubber grommet profiles are often specific to the rim cross-section; so val...
on. The side of the wheel with the valve stem (where you add air) should be facing outward, toward you. Center the wheel on the studs and screw the lug nuts back on, tightening initially by hand. Then use the lug wrench to snug them up—but don't tighten them fully just yet. ...
Once the tire is fully inflated, remove the air pump, remove the adapter, and finger tighten the locknut. Then replace the cap. There is another locknut at the bottom of the valve stem. This should be finger-tightened once the tire is inflated. ...
Each tire on your car has a valve stem that is covered by an air cap. In order to check your tire pressure number, you must remove the caps. It is important not to lose or throw them away. The valve stem caps are what prevents dirt and water from going inside your tires. Additional...
You may use the valve stem as a reference, starting the roll with the valve right over a perpendicular line, and ending when the valve is back at its low point. Another approach is to put a small dot of paint on the tire and measure the distance between the marks that the paint pri...
The horn will sound twice and the TRAIN LEFT FRONT TIRE message will appear on the screen Start from the driver side front tire, use the TPMS Relearn tool to reset the tpms sensor Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the...