To solve this issue, we can calibrate the ESC or set the high and low points as we want. For that purpose, before powering the ESC, first we need to throttle up our potentiometer to maximum or a value at least greater then the current middle point. Then we can power up the ESC, an...
To get a sensitive detector, unfortunately the inputs will need to be measured quite fast. The ATmega running at 16MHz seems to be running fast, still in many cases this is too slow to use standard Arduino based routines. Various approaches „outside“ the standard Arduino routines will be...
If needed we should calibrate the other axis using the same method. And just a quick note that this calibration is not permanently written to the registers. We need to do write these values to the registers at each power up of the sensor. Once we are done with the calibration, ...
We started building the model with three types of relatively small networks formed by 54,000 pore bodies which we used to calibrate basic network topological parameters by fitting the model to the water retention curve and the saturated hydraulic conductivity of the sand sample. Using these ...