This firmware uses another single-board computer, such as the Raspberry Pi, and offloads the intensive calculations to it. Doing so helps the firmware print faster and with better quality using highly accurate stepper motor movements. Klipper firmware is also supported by mostCartesian and Delta 3D...
Welcome to the Klipper project! https://www.klipper3d.org/ Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper. To begin using Klipper start by...
I'm running Klipper (or attempting to) on a Chitu-F board, which has an STM32F103 processor. I tacked on an option for a 34k bootloader (which is what Chitu uses), and can build, encrypt, and flash the firmware onto the board. So far, so good, BUT, the board doesn't do USB ...
MCU 'host' shutdown: Unable to open out GPIO chip line Build file /home/pi/klipper/klippy/../.config(712): Tue May 26 11:19:05 2020 === Last MCU build config === # # Automatically generated file; DO NOT EDIT. # Klipper Firmware Configuration # CONFIG_LOW_LEVEL_OPTIONS=y # CONFI...