gateway A and gateway B are 10.1.1.0/24 and 10.1.1.0/24. Translation from private IP addresses to private IP addresses needs to be performed on the data flow entering from gateway A to the IPSec VPN first. Assume that the post-NAT private IP address is 10.1.2.1. Configure ACLs on both...
To enable static RPs to function normally, perform the same static-rp configuration on all the devices in a PIM domain. # On an IPv4 PIM-SM network, specify different static RPs for group addresses in different ranges and ensure that the static RPs are preferred. <HUAWEI> system-view [~HU...
This ACL will not work. This ACL instructs the router to block the packets that are going to the network 10.0.0.0/8, not to the packets that are coming from the network 10.0.0.0/8. If you apply this ACL to the F0/0 interface, the Students segment will be able to access all three...
Through network address translation (NAT), external users can access the intranet. To ensure intranet security, you can configure ACL rules and apply them to the enterprise router so that only specific external users can access the intranet. ...
Incoming/Outgoing chmod - The chmod parameters allow rsync to set ACLs on the files during the transfer process. This can be crucial when the source and destination should have different permission sets. However, the directives that set security are even more important. Because rsync is a lean ...
You can also use an extended ACL to filter traffic based on protocol information (IP, ICMP, TCP, UDP). The configuration of anextended ACL in a Cisco routerfor TCP is as follows: 3. Dynamic ACL Dynamic ACLs, rely upon extended ACLs, Telnet, and authentication. This type of ACLs are of...
ACLs at both ends of the VPN connection do not match. SA lifetime settings at both ends of the VPN connection are different. Dead Peer Detection (DPD) is not configured on the device in your on-premises data center. Configuration is modified when the VPN connection is in use. ...
protect your network (after passwords) is to decide which traffic can enter and leave your router. Access control lists (ACLs) are a set of filters that the traffic is checked against. If the traffic matches the ACL, it can be either permitted or denied, depending on what you have ...
Extend-IP ACLs analyze and process data packets based on a series of match conditions, which can be the source IP addresses, destination IP addresses, IP protocol and other information of this sort carried in the packets. In this case, we want to achieve the demand that the PC (or other...
An ip address was configured on the port channel, and a route-map was configured. The router-map is to match IP address ACLs and set the interface/next hop. I never use this type of routing policy before, and is there any documents for this? I mean the route-map policy in port chan...