set up:Sep 01 22:04:16 raspberrypi hass[787]: * [homeassistant](https://home-assistant. ...
导入中途如果弹出“SHA Digest of file does not match manifest”的提示,就把下载的ova文件扩展名改成.rar,用winRAR解压缩,解压缩之后删除文件夹里的home-assistant.mf文件,删除后返回第二步选择解压缩出来的home-assistant.ovf文件导入,正常的话这一步可忽略: 5.我的计算机下出现新的虚拟机,导入成功。HomeAssist...
Finally, to solve the problem of the screen being stuck on 'waiting for the Home Assistant CLI to be ready', I had to make sure all partitions on the drive were removed. This was necessary because Balena Etcher doesn't completely wipe the disk. Then, I connected the target disk to an ...
local_ip = await async_get_source_ip(hass) File "/snap/home-assistant-snap/487/lib/python3.9/site-packages/homeassistant/components/network/__init__.py", line 44, in async_get_source_ip raise HomeAssistantError( homeassistant.exceptions.HomeAssistantError: Could not determine source ip because...
因此完全可以不用单独安装homeassistant, 只是supervised的安装后ha的安装受网路的限制比较慢,最好科学上网,否则会非常慢。 完全照官网的方法安装,然后登录ha后在配置里显示几项错误,且无法修复,于是重新写了64位系统,还是出现这些错误: 于是又刷回32位系统,这回在安装的时候针对报错去解决, ...
直接安装Home Assistant 如果您更喜欢手动安装家庭助理核心,那么本文就是为您准备的。 首先执行 Linux 系统的升级。 sudo apt update && sudo apt upgrade -y 1. 升级后,如果需要,我们可以重新启动系统。 [ -e /var/run/reboot-required ] && sudo reboot ...
synoservice --status 通过 cli 设置邮件：synosyslogmail 检查升级：synoupgrade --check 3 转储有关您...
6、安装完成后按ctrl + c 退出查看，输入命令重启HomeAssistant。ha host reboot# 重启HomeAssistant 7...
1. With the Home Assistant CLI open on your Raspberry Pi, you will need to exit out and return to the normal terminal. To access the normal terminal, you will want to use the following command within the terminal. loginCopy 2. Now that we are within the normal terminal, we can begin...
name:${device_name}_reboot time:-platform:sntp id:AC_time timezone:CST-8update_interval:15min uart:id:ddsu666_uart rx_pin:D1tx_pin:D2baud_rate:9600data_bits:8stop_bits:1modbus:id:${device_name}_modbus send_wait_time:200ms