Learn the key considerations and get practical tips for conducting power electronics control hardware-in-the-loop (HIL) testing using Simulink®and Speedgoat real-time target machines. Read this white paper to learn how to: Select appropriate model fidelity Account for processor and I/O latency C...
2.A hardware-in-loop simulator was built based on Matlab/Simulink platform,and the hardware-in-loop simulations were performed for the cases of the vehicle steering brake and double-lane steering.建立了基于Matlab/Simulink平台下的硬件在环试验平台,针对转向制动和双移线转向行驶两种工况进行了硬件在环仿真...
In this paper, in the light of the diversity of space-crafts in space information network and the fast switching characteristics of network nodes, a hardware in the loop(HITL) test-bed is designed and built for testing and evaluating the appointed space information network, which consists of th...
Hardware-in-the-loop (HIL) is being used to investigate aircraft power systems by using a combination of hardware and simulations. This paper considers two different real-time simulators in the same HIL configuration. A representative electrical power system is removed from a turbine engine ...
The main problem in the HILS when contact occurs in the hardware experiment is the energy increase due to delay times in the loop. The paper briefly introduces a compensation method based on the coefficient of restitution.Satoko ABIKOYoshikazu SATAKE...
This paper describes the development of a hardware-in-the-loop (HIL) simulator to support the design and testing of novel fault tolerant control and condition monitoring schemes for fluid power systems emphasizing flight control applications. The simulator uses a distributed architecture to share, in...
A hardware-in-the-loop (HIL) simulation of a wind energy conversion system has been developed using energetic macroscopic representation. Wind, turbine and mechanical power train are emulated by controlled DC drive to impose the dynamical behavior of the actual process on the generator shaft. In ...
Error analysis Hardware-in-the-loop simulation Radar targets Scattering parameters 1. Introduction To test and evaluate the performance of radar systems, a simulation system is indispensable. Fully digital simulation is hard to simulate the real electromagnetic environment of the target. While in fully...
This paper is presented in two sections: To achieve future realism in image generation systems for hardware-in-the-loop (HWIL) testing a significant increase in processing power is required, but additionally a suitable architecture is essential to provide low latency response on the data flow. ...
A High Current, High Frequency Modular Multiphase Multilevel Converter for Power Hardware-in-the-Loop Emulation This paper presents a simple Modular Multiphase Multilevel Converter (MMPMC) especially for the usage in Power Hardware-in-the-Loop Emulation systems. Stan... A Schmitt,M Gommeringer,J...