/* Standard mode, output slew rate control is enabled */ IOCON_PIO_SLEW_STANDARD | /* Input function is not inverted */ IOCON_PIO_INV_DI | /* Enables digital function */ IOCON_PIO_DIGITAL_EN | /* Open drain is disabled */ IOCON_PIO_OPENDRAIN_DI); /* POR...
config->parityMode = kLPUART_ParityDisabled; config->dataBitsCount = kLPUART_EightDataBits; config->isMsb = false;#if defined(FSL_FEATURE_LPUART_HAS_STOP_BIT_CONFIG_SUPPORT) && FSL_FEATURE_LPUART_HAS_STOP_BIT_CONFIG_SUPPORT config->stopBitCount = kLPUART_OneStopBit;#endif#if defined(...
Flow Control Disabling: All ports are in the same VLAN and flow control is disabled. 7 Port indicator status switch button NOTE: Port status: The port indicator indicates the data transmission status of the port. PoE status: The port indicator indicates the PoE status of the port. 8 Gr...
UDLD—Port has UniDirectional Link Detection (UDLD) disabled, shutdown, or in undetermined state. Flow control and PortFast—Port has received flow control disabled or if it has PortFast enabled. High Availability—Redundant Supervisor Engine is present but high availability (HA) is disabled. Boot ...
- Off The GNSS service is disabled. SIM1/2 SIM card indicator Green Steady on A SIM card is installed in slot SIM1 and is working normally. If both slots SIM1 and SIM2 have SIM cards installed, the SIM1/2 indicator shows the working state of the currently activated SIM card. - Off...
Off—Bypass mode is disabled. Green—Port is in standby mode. Amber, flashing—Port is in hardware bypass mode, failure event. 11 Six network activity LEDs: Amber—No connection, or port is not in use, or no link or network failure. Green—Link up, no network activity. Gre...
packagemainimport("fmt""github.com/jaypipes/ghw")funcmain() {block,err:=ghw.Block()iferr!=nil{fmt.Printf("Error getting block storage info: %v",err) }fmt.Printf("%v\n",block)for_,disk:=rangeblock.Disks{fmt.Printf(" %v\n",disk)for_,part:=rangedisk.Partitions{fmt.Printf(" %v...
// _onReceive and _rxTimeout have be consistent when timeout is disabled bool _onReceiveTimeout; Dec 21, 2022 Fixes inconsistencies and adds extended HardwareSerial examples (#7412) 180 uint8_t _rxTimeout, _rxFIFOFull; Mar 2, 2022 Adds C++ std::function to Serial.onRec...
In fact, even standardized OpenMP directives, which would allow explicit parallelization, must be explicitly disabled by the SPEC run rules. There are SPEC benchmarks that primarily stress floating point performance and other benchmarks that primarily stress integer and control flow performance. The ...
The default configuration for serial devices is for hardware handshaking to be disabled. This setting allows "three wire" serial cables to work; they don't support the necessary signals for hardware handshaking, and if it were enabled by default, they'd be unable to transmit any characters to...