Samsung Galaxy Ultra 21 with 5G and it was 10 times faster than this phone and better it would boot up in less than 3 seconds this one you got to hold the button for 10 seconds just to turn on the screen when you shut it off and it takes fo...
S5732-H48UM2CC 2.5&10G Bundle(36*100M/1G/2.5G, 12*100M/1G/2.5G/5G/10G Ethernet ports, Optional RTU upgrade to 5/10G, 4*25GE SFP28, 2*100GE QSFP28 ports, 1*expansion slot, PoE++, with AC power supply) By default, the first 36 multi-GE ports support...
If needed, you can run the factory-configuration prohibit command in the system view to disable the function of restoring the factory settings by holding down the RESET button. To enable this function again, run the undo factory-configuration prohibit command. 3. USB interface 2.0 (host) 4....
If needed, you can run the factory-configuration prohibit command in the system view to disable the function of restoring the factory settings by holding down the RESET button. To enable this function again, run the undo factory-configuration prohibit command. 3. USB interface 2.0 (host) 4....
To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. 2 Twenty-four PoE++ 100M/1000M/2.5GE...
To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. 10 Ground screw NOTE: It is used with a ground...
If Cat5e and Cat6 unshielded twisted pairs do not meet the 5G requirement, you are advised to replace them with shielded twisted pairs or reduce the rate of ports to 2.5G. If Cat5E, Cat6, or Cat6A unshielded twisted pairs are used on electrical ports working at 10 Gbit/s, severe prob...
S5736-S24UM4XC 10G Bundle(24*100M/1G/2.5G/5G/10G Ethernet ports, 4*10GE SFP+ ports, 1*expansion slot, PoE++, 1*1000W AC power) The 10GE RTU license for 24 multi-GE ports has been activated in factory default settings. You can run the assign group-speed command to configure thes...
To restore the factory settings and reset the switch, hold down the button for at least 6 seconds. To reset the switch, press the button. Resetting the switch will cause service interruption. Exercise caution when you press the PNP button. 2 One MODE button 3 Sixteen 10/100/1000BASE-T...
I have factory reset, you name it, Wifi sucks on this phone. Hopefully newer Wifi 7 drivers fix it. Thanks. Proof of Wifi 7 https://www.qualcomm.com/snapdragon/device-finder/samsung-galaxy-s23-ultra https://www.qualcomm.com/products/technology/wi-f...