Configured—Link is not operational or remains down due to a configuration mismatch. The link is not available for switchover from failure of an active link. Hot Standby—Link is ready to take over if an active link fails and can immediately transition to Active...
Configured—Link is not operational or remains down due to a configuration mismatch. The link is not available for switchover from failure of an active link. Hot Standby—Link is ready to take over if an active link fails and can immediately transition to ...
NMI_HARDWARE_FAILURE錯誤檢查的 值為 0x00000080。 這個錯誤檢查表示硬體故障已發生。 重要 本文適用于程式設計人員。 如果您是在使用電腦時收到藍色螢幕錯誤碼的客戶,請參閱針對藍色畫面錯誤進行疑難排解。 NMI_HARDWARE_FAILURE參數 無 原因 各種硬體故障可能會導致NMI_HARDWARE_FAILURE錯誤檢查。 確切的原因很難判斷...
错误检查 0x17B PROFILER_CONFIGURATION_ILLEGAL 错误检查 0x17E MICROCODE_REVISION_MISMATCH 错误检查 0x189:BAD_OBJECT_HEADER 错误检查 0x18B:SECURE_KERNEL_ERROR 错误检查 0x18C:HYPERGUARD_VIOLATION 错误检查 0x18D:SECURE_FAULT_UNHANDLED 错误检查 0x18E:KERNEL_PARTITION_REFERENCE_VIOLATION ...
The NMI_HARDWARE_FAILURE bug check has a value of 0x00000080. This bug check indicates that a hardware malfunction has occurred.
If a mismatch is found, contact technical support as soon as possible. Record the IDs of slots where modules are installed and cable connections on ports of the original device. Back up configuration data of the original device. Power off the original device. The device is successfully powered...
HARDWARE_INTERRUPT_STORM 错误检查的值为 0x000000F2。 这表示内核检测到了中断风暴。 重要 这篇文章适合程序员阅读。 如果你是在使用计算机时收到蓝屏错误代码的客户,请参阅蓝屏错误疑难解答。 HARDWARE_INTERRUPT_STORM 参数 参数说明 1连接到风暴中断向量的 ISR(或链中的第一个 ISR)的地址 ...
ERROR:[Labtools 27-1974] Mismatch between the design programmed into the device XC7K325T_0 and the probes file xxxx/impl_1/debug_nets.ltx. The device design has 0 ILA core(s) and 0 VIO core(s). The probes file has 1 ILA coe(s) and 0 VIO core(s). ...
Resolving a Config Mismatch If the newly installed RAID controller was previously configured, a message displays during POST, stating that there is a configuration mismatch because the configuration data in the NVRAM differs from that in the hard drives. Use these steps to resolve the mismatch: 1...
Resolving a Config Mismatch If the newly installed RAID module was previously configured, a message displays during POST, stating that there is a configuration mismatch because the configuration data in the NVRAM differs from that in the hard drives. Use these steps to resolve the mism...