Device boots up, program works fine but on hard reset it halts Error: Cortex_M3_0: GEL Output: Memory Map Initialization Complete. Cortex_M3_0: GEL Output: Board Reset Complete. Cortex_M3_0: Error: (Error -1170 @ 0x0) Unable...
u8 i, reset;/* 外部中断均为下降沿及低电平中断 */ EXTI_CR1 = 0x00;/* STM8S103F3P6 PA...
PROCESSOR_HALT_CACHE_FLUSH_OVERRIDE0x01PEP 的Halt回调例程负责刷新处理器的缓存。 如果未设置此标志,ProcessorHalt将在进入处理器空闲状态时刷新缓存,并在退出此状态时使缓存失效。 PROCESSOR_HALT_CACHE_COHERENT0x02准备处理器以进入空闲状态,处理器的缓存将保持一致。
while (CLK_GetFlagStatus(CLK_FLAG_LSERDY) == RESET);//等待时钟源就绪 RTC_WakeUpCmd(DISABLE);/...
In such a case, RTT would not be activated on attach, and your application would still hang in the print routine, as the buffers are not emptied. Please note: Some targets have a reset as part of the device specific connect. This reset is currently also executed when attaching to the de...
CORTEX_M3_0: Error connecting to the target: (Error -2062 @ 0x0) Unable to halt device. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 5.0.762....
的Reset&halt,则可以通过两个步骤轻松启用正确的复位: 2.1修改启动代码 在startup代码中添加下列指令: // // Perform a dummy read access BMRTECH2023-05-18 13:55:01 伺服轴状态机功能块介绍 本节结合伺服轴的状态机介绍MC_Halt和MC_Stop功能块,对比了两个功能块执行时状态机的变化,及用法上的区别。 2_...
unsigned rb;reset_sighandlers_and_unblock_sigs(); run_shutdown_and_kill_processes();---执行inittab中的SHUTDOWN action。m="halt"; rb=RB_HALT_SYSTEM;---默认是halt magic。if(sig ==SIGTERM) {---对应reboot magic。m="reboot"; rb=RB_AUTOBOOT; }elseif(sig ==SIGUSR2) {---对应poweroff ...
I also changed the settings to connect under reset , but I still can't connect to the board, and the FAIL.txt still pops up. The LD1, turns green, when i connect through the ST-Link utility, but I still receive the Warning-message as seen on the figure. Based on ...
CLK_LSEConfig(CLK_LSE_ON);while (CLK_GetFlagStatus(CLK_FLAG_LSERDY) == RESET);CLK_RTCClock...