Unlike a Gibson, it has only one volume and one tone control, so one accesses that palette of tone differently. A plus- I can do volume-pot roll-ons more easily than with a 4-knob setup. It stays in tune, and is happiest when playing with a good tube amp set just at breakup –...
It also felt like the master volume pot had an unusual audio taper to it so it was too loud at 2! Also the on board compressor was a bit weak to me. Im sure its a great amp as many have said but not for me. So the search continued and I ended up on an unlikely choice. ...
The920D Custom S5W-BL wiring harnesscomes with a 250k master volume, 250k master tone, and a 250k “no-load” blender pot, which allows you to blend in the tone of the neck pickup when you’re in the bridge position. The kit comes with a standard five-way switch. Again, the wi...
The volume pot is scratchy and I want to replace it with CTS, but not sure which ohm. Thanks, Matt Rushton says: at 10:51 am Chuck your best bet to get that is to e-mail Fender directly. Here’s their e-mail address: consumerrelations@fender.com ted hosfer says: at 8:03 ...
MXR M102 Dyna Comp Guitar Compressor 说明书 Explanation of Controls Front Panel Volume – Always important, this pot can be used to achieve the desired level balance between the sound through the compressor and the bypassed sound. Balance this with the sustain pot to provide as natural an effect...
This could very well just be the specific one that I got but the neck and headstock had a lot of dust and a slightly cloudy residue on them, the fretboard was very dry, and the frets were scratchy. None of these were anything that a little lemon oil, fretboard conditioner, a micro...