[-default]Restore path to its default group [-from]Filter by paths starting at these path startpoints [-to]Filter by paths terminating at these path endpoints [-through]Consider paths through pins, cells or nets [-quiet]Ignore command errors ...
Only the tunnel interfaces of a GRE tunnel support this command. The redirect multi-fed and selective receiving function supports only the forwarding of IPinIP, TCP, UDP, GRE, ESP, and AH packets. In the scenario where LAN-side packets are Ethernet Layer 2 packets, Ethernet over GRE can be...
The sensor-path command configures the sampling path for a Telemetry sensor. By default, no sampling path for a Telemetry sensor is configured. Format sensor-path path { depth depth | condition express op-field field op-type { eq | gt | ge | lt | le } op-value value [ { and | or...
When a command for adding or resigning a path is presented to a reserved device via one path in a group the reserve is automatically realigned to the enlarged or reduced group. When a command for disbanding a group is presented to a reserved device the reserve is realigned to apply only...
aSysmgr becomes unresponsive during execution of the showspace command. Sysmgr变得无答复中展示空间命令的施行。 [translate] areal tech problem is bandwidth 真正技术问题是带宽 [translate] aBAR counter lamp 酒吧逆灯 [translate] aroad tankers 公路槽车 [translate] aCourtesy of hospitality 好客礼貌 [...
When a command for adding or resigning a path is presented to a reserved device via one path in a group the reserve is automatically realigned to the enlarged or reduced group. When a command for disbanding a group is presented to a reserved device the reserve is realigned to apply only...
Using the aggregation command without as-set: Routes are summarized without AS-set. Failing to make a policy effective: The policy will not work. Possible Causes The maximum number of AS_Paths supported is too small. The AS_Path attribute in the received routes is too long. ...
Check the status of member interfaces in the Monitor Link group. Run the display monitor-link group group-id command and check the State field in the command output. If the State field of a member interface is DOWN, rectify the interface Do...
# Run the display vrrp command on SwitchA. You can see that SwitchA is the master in VRRP group 1 and the backup in VRRP group 2. [SwitchA] display vrrp Vlanif100 | Virtual Router 1 State : Master Virtual IP : 10.1...
You can run the vrrp vrid virtual-router-id priority priority-value command to change the priority of an IP address owner, but the configured priority does not take effect. If a VRRP device is no longer an IP address owner, the configured ...