If rootfs does not contain an init program after the embedded cpio archive is extracted into it, the kernel will fall through to the older code to locate and mount a root partition, then exec some variant of /sbin/init out of that. All this differs from the old initrd in seve...
This in turn introduces the constraint of needing to use a 32-bit ARM binary, as Plex currently does not have a 64-bit build available. The first bit of fun I found was that while the Docker project has community provided support for AArch64, Docker, Inc does not actually provide AArch...
(LVD): reset outputs Interruption 8 level, Generate interrupts and ‒ External: 6 to 16 factors, with DNF ‒ internal: 85 to 100 factors ● I/O ports: GPIO:24 to 87(Input:2 to 4,Output:1) ‒ pull-up/-down resistor, Open-drain, 5V-tolerant ● On chip Debug(JTAG/SW) ...
omap_voltage_add_dev: VDD specified does not exist! OMAP GPIO hardware version 0.1 OMAP GPIO hardware version 0.1 ti8168_evm mode HuanYi NVCT 4.2 Linux version 2.6.37+ omap_mux_init: Add partition: #1: core, flags: 0 _omap_mux_get_by_name: Could not find signal i2c2_scl.i2c2_...
Additional options: CONFIG_LED_STATUS_GPIO The status LED can be connected to a GPIO pin. In such cases, the gpio_led driver can be used as a status LED backend implementation. Define CONFIG_LED_STATUS_GPIO to include the gpio_led driver in the U-Boot binary. CONFIG_GPIO_LED_INVERTED_...
Flashinggpio_toggle_output, then stopping debugging, then starting debugging again, it works perfectly fine 100% of the time. Flashing tima_timer_mode_periodic_repeat_count, however does not work perfectly. 1st ...
This, however, does not imply any glitch rejection on the GPIO pins. The GPIOs are available in Standby Mode and Active Mode. GPIO state transitions are not tracked in shutdown mode. 8.3.7 Power Management Features TCA5013 has a DC-DC boost and card LDOs that enable it to generate ...
Many Stellaris GPIO will accept 5V when configured asinput. (there are exceptions - such as ADC, few others - which do not allow) Referencing MCU data manual - see if that specific GPIO enables output configuration as, ...
13. The electronic device of claim 1, wherein selectively providing to the portable electronic device one or more commands of the set of remote-control commands further comprises providing the portable electronic device a subset of the remote-control commands that does not include the entire set ...
13. The electronic device of claim 1, wherein selectively providing to the portable electronic device, from the interface circuit, a command of the set of remote-control commands further comprises providing the portable electronic device a subset of the remote-control commands that does not include...