Many current-model turning centers have two sets of offsets: Geometry offsets are used to assign program zero during setup, and wear offsets are used to make sizing adjustments during the production run. When users view these offsets on the display screen, they look very similar. Each will...
Although there are other parameters that go into what makes the front wheel behave, (fork offset, trail, etc) this is the key metric that the industry uses to determine front-wheel characteristics. A “slack” mountain bike head angle is a lower number (eg: 65°) relative to a “steep...
In both cases the mismatch is produced by replacing a single radius of curvature by two, with offset centers, resulting in a line contact. Herzian stresses are reduced, but not eliminated. Geometry of this invention is also characterized by the fact that the aspherical component of the ...
Separating the use of geometry and wear offsets.(CNC Tech Talk)Lynch, Mike
The mechanical losses and wear of the pneumatic system could not account for the dynamic response of boost pressure, but the wear detection is enhanced in the eVGT through the offset learning. The cushioning of the mechanical stop position is provided. Improvement in engine out emissions was ...