I think, you should temporary use relative moves for the e axis (retraction and purge), and you probably don't want to use the G92 command at all. But of course it depends on the coordinate mode that is used at the moment your pause occurs. ...
When one is received it is stored, but it is not acknowledged to the host until the buffer is exhausted and then the command has been executed. Thus the host will pause at one of these commands until it has been done. Short pauses between these commands and any that might follow them ...
The following commands are not buffered. When one is received it is stored, but it is not acknowledged to the host until the buffer is exhausted and then the command has been executed. Thus the host will pause at one of these commands until it has been done. Short pauses between these c...
They have published a command set at http://pthat.com/index.php/command-set/ It’s a bit limiting in that they have it defined to support 4 axis, but it would not take a lot of effort to extend it to more (some thought would have to be put as to how to sync multiple boards)...
conn.pause(param); } } 开发者ID:rkoeppl,项目名称:Repetier-Host,代码行数:13,代码来源:Main.cs 示例7: writeString ▲点赞 1▼ privatevoidwriteString(BinaryWriter file,stringcode,boolbinary){GCodegc =newGCode(); gc.Parse(code);if(gc.hostCommand)return;if(binary) ...
32、ed it is stored, but it is not acknowledged to the host until the buffer is exhausted and then the command has been executed. Thus the host will pause at one of these commands until it has been done. Short pauses between these commands and any that might follow them do not affect...
4.4.18 M25: Pause SD print 暂停SD卡打印 4.4.19 M26: Set SD position 4.4.20 M27: Report SD print status 4.4.21 M28: Begin write to SD card 4.4.22 M29: Stop writing to SD card 4.4.23 M30: Delete a file on the SD card
When one is received it is stored, but it is not acknowledged to the host until the buffer is exhausted and then the command has been executed. Thus the host will pause at one of these commands until it has been done. Short pauses between these commands and any that might follow them ...
Release SD card 4.4.7 M23: Select SD file 4.4.8 M24: Start/resume SD print 4.4.9 M25: Pause SD print 4.4.10 M26: Set SD position 4.4.11 M27: Report SD print status 4.4.12 M28: Begin write to SD card 4.4.13 M29: Stop writing to SD card 4.4.14 M40: Eject 4.4.15 M41: Loop...
object. One thing you could do is move the object back with a G1 command. You can do this, because the host remembers the position, where the pause started. After you hit the continue button, the extruder will go back to the starting position. Things you shouldn’t do during pause ...