Calling FT_Open return FT_DEVICE_NOT_OPENED Diagnostic Logs Following FTDI installation guide (https://ftdichip.com/wp-content/uploads/2020/08/AN_220_FTDI_Drivers_Installation_Guide_for_Linux-1.pdf) In Linux, the VCP driver and D2XX driver are incompatible with each other. When a FTDI device...
Verifying Hash Integrity ... crc32+ sha1+ OK Flattened Device Tree from FIT Image at 02000000 Using 'config-1' configuration Trying 'fdt-1' FDT blob subimage Description: POWERPC OpenWrt extreme-networks_ws-ap3825i device tree blob Type: Flat Device Tree Compression: uncompressed Data Start: ...
When BDBUS is used as a serial port and opened, the red light in LED5 is always on, which is the indicator of hardware flow control, which is a normal phenomenon. The board 93LC56 EEPROM is not in use, so it is indicated as BLANK DEVICE. ...
When BDBUS is used as a serial port and opened, the red light in LED5 is always on, which is the indicator of hardware flow control, which is a normal phenomenon. The board 93LC56 EEPROM is not in use, so it is indicated as BLANK DEVICE. ...
When BDBUS is used as a serial port and opened, the red light in LED5 is always on, which is the indicator of hardware flow control, which is a normal phenomenon. The board 93LC56 EEPROM is not in use, so it is indicated as BLANK DEVICE. ...
avrdude: ser_open(): can't open device "\\.\COM5": Access is denied. ⓘThis unexpected result is caused by a separate bug:Port left open after closing Serial Plotter#1423 Expected behavior Serial Monitor and Serial Plotter do not interfere with upload process. ...