as it's tall enough. For this approach, you can buy cheap hole saw kits like these,https://www.amazon.c...811832278&psc=1and just before drilling into the foam, heat the saw blade with a portable butane torch. This will allow you to make a smooth cut in the foam and seal the ed...
also use the tape measure to mark the center of the deck panel, take the rim of the gama seal lid and find where it will be centered on the deck panel and clear of the bulkhead. Now
You could tape at each rafter and overlap two pieces to completely seal it. Other than that I think you’ve done a pretty good job. Reply Kris Can You spray foam over XPS foam Board? Reply donna We are looking to insulate our pole barn to knock off some of the cold air for ...