receiveoff 和 sendon:如果远程设备支持流控制,该端口就发送暂停帧;但是该端口不支持来自于远程设备的暂停帧。 receiveoff 和send desired:如果连接的设备支持流控制,而该端口不能够接收暂停帧但能发送暂停帧。 receiveoff 和 send off:流控制不任何一个方向上执行。在拥塞事件中,没有指示给链路伙伴,并且...
Receive Flow Control Enable When this bit is set, the MAC decodes the received Pause frame and disables its transmitter for a specified (Pause) time. When this bit is reset, the decode function of the Pause frame is disabled. ValueDescription 0x0 DISABLED 0x1 ENABLED RW 0x0 1 tfe Tra...
Enable received flow control auto-negotiation. Run system-view The system view is displayed. Run interface interface-type interface-number The Ethernet interface view is displayed. Run negotiation auto The interface is configured to work in auto-negotiation mode. Run flow-control negotiation recei...
Enable received flow control auto-negotiation. Run system-view The system view is displayed. Run interface interface-type interface-number The Ethernet interface view is displayed. Run negotiation auto The interface is configured to work in auto-negotiation mode. Run...
Transmits PFC-PAUSE frames when the receive threshold for a particular traffic class is reached Provides the management capability for an administrator to configure the flow control properties on each port of the switch Keeps flow control disabled for all priorities on all ports by default Allows an...
The cmdlet immediately returns an object that represents the job and then displays the command prompt. You can continue to work in the session while the job completes. To manage the job, use the*-Jobcmdlets. To get the job results, use theReceive-Jobcmdlet. ...
To enable ECN on the hosts: Load mlx5ib(4) and mlx5en(4): # kldload mlx5ib mlx5en Query the relevant attributes: # sysctl -a sys.class.infiniband.mlx5_<devno>.cong.conf Modify the attributes: # sysctl sys.class.infiniband.mlx5_<devno>.cong.conf.<attr>=<value> ...
For instance, the command 'ethtool -A vmnic0 rx on tx on' would enable flow control for transmit and receive on nic0. Cheers 0 Reply spmkayser 2010-07-29 02:58 AM 11,902 Views Hijacking this thread a bit. Is anyone aware of why exactly one should employ the recommended flow...
this case, the slave can receive a new packet with CRC although its RX buffer is still not emptied. The slave shall then return a NAK in response to this packet even if the packet passed the CRC check. The FLOW bit is not used on the eSCO logical transport or the ACL-C logical ...
switch is capable of both sending and receiving pause frames (called symmetric flow control), enable negotiation in both directions (send desired and receive desired). If the switch only supports receiving pause frames (asymmetric flow control), then enable negotiation for receive only (receive ...